User manual KOMPERNASS KH 4012 DECORATIVE, NATURAL-STONE INDOOR WATER FOUNTAIN

[. . . ] Carefully put the natural-stone "cascade" body on to the natural-stone bank in a way that the fixed hose is can be in- Serted into the hose connection piece of the water pump. At the same time, push the water pump with plug adaptor to meet the hose. Do not damage the water-resistant lamp when placing the natrual-stone "cascade" body. [. . . ] Do not use your natural-stone water fountain on a low water level. Make sure that the pump will always be covered by water. If the water basin has a low water level and the pump is not completely covered by water while the natural-stone water fountain is in operation, please unplug the transformer and fill the water basin with distilled water up to the , , MAX" mark before starting again. You will now be able to adjust the pumping rate with the rotating switch at the front of the water pump: · ⷠRotate towards "MIN" for lower pumping rate Rotate towards "MAX" for higher pumping rate The pumping rate of the water pump is infinitely variable and allows to adjust higher or lower water flow when the naturalstone water fountain is in operation. Replace the natural-stone "cascade" body to its original position on the natural-stone bank and place the decorative stones in the water basin. From dust) may cause malfunction during operation; this may cause damages to the water pump!Replace dirty water by fresh distilled water once a week. Carefully take the natural-stone "cascade" body from the natural-stone bank. Take the natural-stone bank with the fixed water pump out of the water basin. Disconnect the water pump power cable from the transformer power cable. Take the natural-stone "cascade" body with the fixed water pump from the natural-stone bank. Take the natural-stone bank with the fixed water pump from the water basin. Replace the natural-stone bank with the fixed water pump to their original position in the water basin. Replace the natural-stone "cascade" body to its original position on the natural-stone bank. Lead the power cable of the water pump to the fixed cable clamp at the rim of the water basin and out of the water basin. Insert the plug of the water pump power cable to the plug of the transformer power cable. Disconnect the power cable of the water pump from the transformer. remove the decorative stones from water basin. [. . . ] Insert the plug of the water pump power cable to the plug of the transformer power cable. In case the water pump was not covered by water overheating of the pump may result from the low water level. Fill the water tank with distilled water up to the "MAX" mark. [. . . ]