User manual KOMPERNASS KH 4106 MINI-COMPRESSOR

[. . . ] Komponenten . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Vor dem Zusammenbau . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Zusammenbau der Komponenten . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Aufstellort . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Carefully place the natural-stone cover plate on the water tank as shown in drawing no. The plastic pins on the bottom of the natural-stone cover plate must be inside the water tank to secure a fixed position of the cover plate. IRL Operating Instructions | . Placing the Natural-Stone Water Fountain Place the natural-stone water fountain on a level, scratch-resistant and non-slippery surface. Do not place the natural-stone water fountain on surfaces that may be damaged by moisture (e. g. furniture, electrical equipment, such as TVs, Video Recorders etc). . Safety Instructions Warning! To prevent the danger of an electrical shock, do not expose the connecting cable or the mains plug to moisture or dripping water! . Putting into operation When the assembly is finished and a suitable place for the natural-stone water cascade was selected . . . Connect the water pump wire cable to the transformer wire cable. Attention! Never leave the natural stone water fountain unattended during operation, this to ensure that in the case of malfunctions the power supply is disconnected. It is most important to check the water level in the water tank during operation!A low water level may cause overheating to damage the water pump!If the natural water pump is in operation and the water level in the water tank is too low, overheating may cause damage to the water pump! Fill the water tank with distilled water to "MAX" mark. Replace the natural-stone cover plate to the water tank. Connect the water pump wire cable to the transformer wire cable and plug the transformer in a mains socket. Your natural-stone water fountain is ready for operation again. . Water-resistant lamp does not work If the water-resistant lamp is not working, replace the halogen bulb. Unplug the transformer. Disconnect the water pump wire cable from the transformer wire cable. Carefully remove the natural-stone cover plate from the water tank. Carefully take the natural-stone "tower" out of the water. Do not disconnect the hose connections between water pump and natural-stone "tower". Place the water cascade beside the water tank. Remove the lamp from the plastic clip fixed on the front side of the natural-stone "tower". [. . . ] Podnie ostronie konstrukcj wodospadu ze zbiornika na wod i przytrzyma przy tym pomp wodn, aby w Polczy wtyczk sieciow na kablu sieciowym pompy wodnej z wtyczk na kablu zasilacza sieciowego i podlczy zasilacz sieciowy do gniazda. Dekoracyjny wodospad pokojowy jest teraz ponownie gotowy do pracy. | Instrukcja obslugi . Wodoszczelna lampa nie dziala Jeli lampa wodoszczelna nie wieci si, naley wymieni arówk halogenow na now. Wycign zasilacz sieciowy z gniazda. Obróci ostronie klosz ochronny i pocign jednoczenie za niego, aby zwolni go z uchwytu na lamp. [. . . ]