User manual KOMPERNASS KH 4164 DESK LAMP

[. . . ] Do not leave the appliance unattended at any time when it is in use. Do not locate the appliance below inflammable objects, especially not in the vicinity of curtains and drapes. Do not place the appliance at locations where, should it inadvertently tip over, it would land on easily inflammable materials, e. Soft furnishings, beds, waste paper baskets etc. [. . . ] When changing the bulb ALWAYS use the supplied suction disc. Do not attempt to change the bulb with your bare fingers. If you do, there is the risk of being injured on the housing edges, by splittering glass or being burnt on hot elements. This appliance is not intended for use by individuals (including children) with restricted physical, physiological or intellectual abilities or deficiences in experience and/or knowledge unless they are supervised by a person responsible for their safety or receive from this person instruction in how the appliance is to be used. Children should be supervised to ensure that they do not play with the appliance. First put the components together completely before operating the lamp: · Turn the counterweight q onto the rear of the swivel-arm. Carefully pull the power cable w so far out of the lamp base until the swivel arm is flush in the lamp base. Lock the swivel arm into the lamp base with the hexagon spanner e. Place the suction disc r onto the front of the bulb and press it firmly. Guide the bulb into the bulb holder and secure it by turning it through a quarter-turn in a clockwise direction. Check to ensure that the appliance is undamaged, all component parts are present and that packaging remnants are removed from it. Do NOT operate the lamp with the suction disc fitted ­ it would be melted immediately by the heat. Insert the power cable into the wall socket. You can now switch the lamp on and off at the switch t. Always adjust the position of the lamp with the lever y, not with the lamp housing. You can adjust the swivel-arm in that you first loosen the locking device u. Move the swivelarm to the desired position and then retighten the locking device. Check to ensure that the power plug is removed from the wall socket. If the lamp has been in use, first allow it to cool down completely. This avoids the potential risk of being burnt. [. . . ] Check to ensure that the power plug is removed from the wall socket. If the lamp has been in use, first allow it to cool down completely. This avoids the potential risk of being burnt. Clean the appliance only with a dry or lightly moistened cloth. [. . . ]