User manual KOMPERNASS KH 4182 PAPER FLOOR LAMP

[. . . ] Arrange for defective power cables and plugs to be repaired or exchanged as soon as possible by Customer Services. Use it only in dry rooms, do not use it outdoors or close to liquids. â· Ensure that the power cable can never become wet or moist when in use or that it could be damaged in any way. â· Notice regarding power disconnection To completely disconnect the appliance from mains power, the plug MUST be removed from the power socket. [. . . ] â· Place the lamp where it cannot be knocked over by falling objects. Before changing the light bulb, ALWAYS wait for the bulb and the bulb holder to cool down. Otherwise you run the risk of being burnt on the hot elements. â· This appliance is not intended for use by individuals (including children) with restricted physical, physiological or intellectual abilities or deficiences in experience and/or knowledge unless they are supervised by a person responsible for their safety or receive from this person instruction in how the appliance is to be used. Children should be supervised to ensure that they do not play with the appliance. Q w e r t y u i o a s d Lamp shade End cap Shade retainer rod Bulb Bulb holder Lamp rod Lower shade retainer Lamp base Power cable On/Off foot switch Cap nut Pull-relief for the power cable First put the components together completely before operating the lamp. Ensure that the screw on the pull-relief d of the power cable o on the side of the lamp base i is open and that the cable of the pull-relief d can be moved easily. Now, carefully and slowly pull the power cable o from the lamp base i, whilst at the same time you move the lower end of the lamp rod y towards the thread of the lamp base i. Should difficulties present themselves, first of all pull the power cable o through the central opening on the underside of the lamp base i, and then, after this, through the pull-relief d. When the rod y has reached the thread, screw the lower third of the rod onto the thread of the lamp base i. Next, screw the middle third of the rod y onto the thread of the lower rod element. If need be, once again pull the power cable o a little further out of the lamp base i. When screwing the rod elements together, take steps to ensure the power cable o is not damaged in any way!Now connect the upper third of the rod y with the middle rod component. To do this, position the two components one above the other, as shown below, and push them into each other. Afterwards, turn the upper rod component through approx. Here also, if need be pull the power cable o a little further out. Now secure the screw on the pullrelief d hand-tight with a screwdriver. Under no circumstances may the power cable o be crushed when doing this!Now take the three bulbs r from their packaging and screw them into the bulb holders t. Screw the shade retainer rod e into the thread on the upper end of the lamp rod y. Extend the lamp shade q to its full length and draw it, with the ring retainer pointing upwards, over the lamp rod y. [. . . ] If the lamp has been in use, first allow the bulb to cool down completely. This avoids the potential risk of being burnt. Cleaning the appliance: Clean the appliance only with a dry or lightly moistened cloth. Do not use abrasive or aggressive cleaning agents, these could damage the upper surfaces. [. . . ]