User manual KOMPERNASS KH 3217 SAFETY MAGNET LOCK SET

[. . . ] When installing the lock in drawers, place the installation template q on the upper inside drawer wall at the height of the grip or knob. Fold the installation template q around the corner at the fold line and mark the two screw holes (X) for the lock plate r with a sharp object (such as a nail). Press the door or drawer hard against the sticker . When the door / drawer is opened, the installation template q will have been transferred to the correct location for further installation. [. . . ] Mark the two new screw holes for the lock plate r with a sharp object (such as a nail). While closing the door, mark the position of the installation template q on the narrow part of the inside of the door using a pencil. Carefully remove the installation template q from the inside cabinet wall. Stick the installation template q onto the previously marked position, flush against the inside edge of the door using the sticker (see Fig. Smooth out the installation template q and mark four of the six screw holes (X) (two above and two below) for the lock w. Fig. 2 w e r t y u i o a 4. Slide the drilling depth limiter u onto the 7 mm drill bit based on the door thickness so that the drilled hole will reach to 3 mm from the front of the door / drawer (Fig. Check the drilling depth on the outer edge of the door. Check whether the magnet connector of the lock w fits perfectly into the hole with the T-insert o (see Fig. For thinner doors, leave out the T-insert o. 4 28. 6 mm - 39. 7 mm 15. 9 mm - 28. 6 mm 12. 7 mm - 15. 9 mm Fig. 5 Unlocking bar If you do not wish to use the lock, you can permanently unlock the lock with the unlocking bar t. Press the unlocking bar t over the lock w so that the pins snap into the holes first on one side, then on the other side. The writing "UNLOCK" must face forward. Press the lock latch closed and turn the unlocking bar t forward until reaching the stop (see Fig. To lock the door, make certain that the unlocking bar t is turned back (see Fig. 7 Warranty and service This product comes with a 3-year warranty as of the date of purchase. Please keep your receipt as proof of purchase. Please contact your local service centre regarding warranty issues. Kompernas Service Ireland c/o Irish Connection 41 Harbour view Howth Co. [. . . ] Tip: Place a marking sticker a on the outside of the door to find the correct place to use the magnet key e more quickly. Always place the maget key e at an agreed location near the secured door / drawer. Do not keep the mag-net key e in a clothing pocket and never inside the cabinet being secured. Disposal Do not throw the magnet lock into normal household waste. Dispose of the magnet lock through an approved waste disposal company or your community disposal facility. [. . . ]