User manual KOMPERNASS LERVIA KH 4421 CORDLESS HAND VACUUM CLEANER

[. . . ] Manipulations made by persons other than qualified technicians could represent a health hazard. Before switching the hand vacuum cleaner on, make certain that the mains voltage corresponds to the voltage indicated in the technical data for the appliance. Never touch the power supply or the appliance with wet or damp hands. Do not use the power adapter with an extension cord; connect the power adapter directly to a power socket. [. . . ] · Take special care when using the hand vacuum cleaner on stairs. · Do not use the hand vacuum cleaner without the dust filter inserted. · Do not use the power adapter for a different product and do not attempt to charge this appliance with a different charging station. Only use the charging station supplied with this appliance. -5- KH4421 Before the First Use 1. The cordless hand vacuum cleaner is powered by rechargeable Ni-MH batteries. Before using the cordless hand vacuum cleaner for the first time, the batteries must be charged for at least 24 hours. The batteries reach their full capacity after a charging time of 24 hours. Only place the appliance back in the charging station once the vacuum power becomes noticeably weaker. NOTE: Make certain that the on/off switch is in position "0" before starting the charging process. Important: · Once the charging process is completed, the appliance automatically switches to the charge maintenance function. However, in order to avoid possible damage to the batteries, do not leave the appliance constantly connected to the charging station . · Only place the appliance back on the charging station once the vacuum power becomes noticeably weaker. Important information about the battery In the event of a defective battery, please contact our service centre directly. Please refer to the guarantee card for the Authorized Service Outlet in your country. Charging 1. Insert the round plug of the power supply into the back of the charging station . Lock the plug by turning it anti-clockwise. Place the charging station next to a power socket and plug the power adapter in. The charging station can optionally be mounted on a wall with the supplied screws and plugs (see Chapter , , Mounting the wall bracket"). Vertical screw spacing 102 mm, screw diameter 3, 5 mm. The borehole has to fit for plug diameter 5 mm You can store the crevice tool and the upholstery brush in the slots on the charging station . Place the hand vacuum cleaner in the charging station . The charge indicator light lights up red and the charging process begins. Mounting the Wall Bracket 1. Using the wall bracket to mark the boreholes ensures the correct spacing. Push the plugs into the boreholes and screw in the lower screw until ca. [. . . ] To remove the upholstery brush from the hand vacuum cleaner, press both of the lateral lugs on the tool forward simultaneously. -7- KH4421 Disposal Do not dispose of the device in normal domestic waste. Dispose of the device over a registered waste disposal firm or through your communal waste disposal facility. Observe the currently valid regulations. In case of doubt, consult your waste disposal facility. [. . . ]