User manual KOMPERNASS PARKSIDE KH 3145 PET 23 ELECTRIC TACKER

[. . . ] Page Page Page Page Page Page 6 6 6 6 6 6 Safety Specific safety advice for this tool . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Page 7 Operation Loading the magazine . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Setting the impact force . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Switching on and off . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] J Only use the tool if the mains lead O is undam aged. A damaged mains lead presents a danger to life from electric shock. Have repairs to the mains lead carried out only by an electrician or at the relevant service centre. J Always guide the mains lead O away from behind the hand grip Q to the rear of the tool. J Do not use the tool to fix electrical cabling in place. GB / IE 7 Safety / Operation Attention!J Ensure that staples and nails cannot strike people or animals. This also applies to people who may be helping with the work by supporting or holding the workpiece. J Before you start to use the tool, check that it is in perfect condition. J Make sure the tool is switched off before you load the magazine T. To do this set the On / off switch I to position "O". j Push the magazine slider U into the magazine T until it meets the stop. j Then press the magazine slider U downwards until it has definitely engaged. j Select the lowest impact force required for stapling. j You can set the impact force at any value between "1" (lowest impact force) and "7" (highest impact force) using the impact force controller Y. L To work safely! J Before undertaking any type of work with the tacker make sure that materials and workpieces are safely held in position. If necessary have a second person on hand to support or hold the items steady. J Do not use the tool on moist or wet materials. J If you have finished using the tool or are taking a prolonged break from your work disconnect the mains lead O from the mains. Switching on and off mAttention!J Connect the tool to the mains only when it is switched off. To do this set the On / off switch O to position "O". To switch on j Set the On / off switch I to position "1" (see Fig. To switch off j Set the On / off switch I to position "O". [. . . ] J If you are going to rectify faults disconnect the mains lead O from the mains. Fault Cause Remedy The tool does not work properly. Take off the front plate E with the hexagonal socket screw key P. A staple or nail has been incorrectly driven into the material. [. . . ]