User manual KOMPERNASS PARKSIDE PDS 200 A KH 3167 BENCH GRINDER

[. . . ] Before reading, unfold both pages containing illustrations and familiarise yourself with all functions of the device. The following pictograms are used in these operating instructions / on the device: Read instruction manual!Watts (effective power) Wear hearing protection, dust protection mask, protective glasses and protective gloves. Keep children away from electrical power tools! [. . . ] ½ Before the electrical power tool is used, carefully check the safety equipment and any slightly damaged parts to see that they are still working properly. ½ Check that all moving parts on the tool are working properly, can move freely and are not damaged. All parts must be correctly attached and fulfil all the requirements necessary to allow the electrical power tool to operate properly. ½ Damaged safety equipment and components must be properly repaired or replaced at a competent electrical equipment repair centre unless otherwise indicated in the operating instructions. ⽠Damaged switches must be replaced at a Customer Service Centre. ½ Never use an electrical power tool that cannot be switched on and off properly. ½ The use of inserted tools and accessories other than those recommended by the manufacturer could lead to you being injured. Have your electrical power tool repaired at an electrical equipment repair specialist. ½ This electrical power tool complies with the relevant safety regulations. Repairs may only be carried out by a specialist electrical repair centre using original spare parts, otherwise injury could occur to the user. ½ Do not touch the mains lead if it becomes damaged Or cut through while you are using the device. Pull the plug out of the mains socket immediately and have the device repaired by a suitably qualified person or at your service centre. ½ Do not operate the device if it is damp and do not use it in a damp environment. ½ If you use the device outdoors, always connect it through a residual current device (RCD) with a maximum trip current of 30 mA. General safety advice / Before use If using an extension lead, always use one that is approved for outdoor use. If a dangerous situation arises, pull the mains plug immediately out of the mains socket. Always work with the mains lead leading away from the rear of the device. For this reason, always make sure that nobody is placed in any danger and that there are no inflammable materials near the working area. Working with harmful / noxious dusts represents a risk to the health of the person operating the device and to anyone near the work area. Wear protective glasses, hearing protection, dust protection mask and protective gloves. allow the workpiece to cool sufficiently first. When grinding for longer periods, stop grinding from time to time and allow the workpiece to cool before continuing. [. . . ] Pressing too hard can overload the device. When grinding always use the circumferential end face (not the sides) of the grinding wheel only (See Figures D, E, F). Adjusting the eye guard mounts: 1) To adjust the setting, first loosen the fastening screw 14 . 2) Bring the eye guard mount 2 close up to the grinding wheel 4 , the distance between the grinding wheel 4 and the eye guard mount 2 must be no more than 2 mm. [. . . ]