User manual KOMPERNASS PARKSIDE PEH 900 POWER PLANER

[. . . ] Always keep the power cable fed to the rear of the machine. Only place the planer against the workpiece after switching it on. The base plate ¾ must always lay flat on the workpiece when working. [. . . ] Always make sure when you are planing surfaces such as beams and boards that the base plate ¾ is in full contact with the surface to avoid the danger of blade kickback. Always use both hands to guide the plane over the workpiece with even forward pressure. The vee groove º in the centre of the front of the base plate ¾ allows you to chamfer the corners of your workpiece very quickly and easily. Place the planer on to the workpiece with the vee groove º on the corner and then guide the planer along the corner. Make sure you keep the angle at 45° and an even forward pressure. Example set up: for right hand rebates the side fence ² goes on the left and the rebating depth stop goes on the right into the holes on the planer (with the planer viewed from above). WARNING: Before doing any work on the planer always pull out the plug from the mains. IMPORTANT ADVICE: Do not unscrew the two hexagonal socket headed screws. they adjust the height of the cutting block. Adjustment is only required if you wish to change to another planer blade type e. When you change blades, always change both blades to avoid any imbalance. When they become blunt, the PARKSIDE reversible blades can be changed without any height adjustment of the cutting block being necessary 1) 2) 3) 4) First unscrew one cutting block µ only so that you can use the works-mounted second cutting block as an aid to setting up later. Unscrew the three screws in the cutting block µ using the supplied open spanner. Take the cutting block out of the planing roller. 5) Re-assembly with a reversed or new blade is done in reverse order. 6) Check again for safety: - the position of the planer blade in the cutting block - the balanced and secure seating of the cutting block and the 3 fixing screws - that the height adjustment is correct (2 hexagonal socket headed screws). Unscrew the screws in the cover and take off the toothed belt cover ¶. Cut through the toothed belt with side-cutting pliers or a knife and remove the severed toothed belt. [. . . ] Further practical tips for power tools can be found in the accompanying booklet on safety advice. We reserve the right to make technical modifications in the course of further development. 21, D-44867 Bochum, Germany, hereby declare that this product conforms with the following EC regulations: EC machine guideline: EC low voltage regulations: Electromagnetic compatibility: Applicable harmonised standards: (89/392 EEG), (91/368 EEG), (93/44 EEG), (93/68 EEG) (73/23/EEG), (93/68 EEG) (89/336 EEG), (92/31 EEG), (93/68 EEG) EN 50144-1:1998, EN 50144-2-14:1996, EN 55014-1:1993+A1 EN 61000-3-2:1995+A1+A2, EN 61000-3-3:1995, EN 55014-2:1997 PARKSIDE PEH 900 POWER PLANER 6) Contrôlez ensuite pour votre sécurité - la position de la lame dans le porte-lame - le serrage correct et régulier du porte-lame et des 3 vis de serrage - le réglage correct de la hauteur (2 vis à six pans creux internes). [. . . ]