User manual KOMPERNASS PARKSIDE PFS 710-KH 3136 SABRE SAW

[. . . ] Oscillating action rotary switch Blade speed setting wheel Locking button On/Off switch Hexagonal socket head screw for saw blade exchange Shoe Saw blade Plunger Locating pin Clamp plate Saw blade for wood (quick, coarse cuts) Saw blade for wood (precise cuts) Universal saw blade (flexible cuts) Saw blade The tool is intended for sawing, cutting to length or trimming of securely supported objects made of wood, plastic and building materials. The sabre saw is suitable for rough sawing work, straight and curved cuts and sawing flush. the tool is not intended for sawing metals. When working with metals you must ensure that no metal dust or swarf gets into the ventilation slots of the tool as this could have an adverse effect on safety. [. . . ] 25 mm, 3 TPI Most suitable for: the quick, coarse sawing of wood up to 100 mm thick. Most suitable for: the flexible blade allows flush sawing for coarse work in wood and plastic. Advice about ways of working when sawing Always make sure the saw blade type and the blade speed and oscillation settings are suitable for the workpiece. Narrow blades are best for tight curves. Before sawing, always check the workpiece for foreign bodies such as nails, screws etc. Do not allow the ventilation slots to become covered. Switch the tool on and only then bring it into contact with the workpiece. The shoe must always be set against the workpiece surface. Saw through the workpiece using even pressure and speed of progress. If the saw blade jams, switch off the tool immediately. Open the sawn split in the workpiece slightly using a suitable tool and extract the saw blade. Flush sawing: You can use the supplied universal saw blade or a flexible bimetal saw blade to saw projecting workpieces (e. Slowly plunge the saw blade into the workpiece. As soon as you have reached the required depth of cut, bring the blade into the vertical position and continue sawing along the cutting line. Finally switch off the sabre saw and lift the blade from the workpiece. Remove the mains plug from the socket before carrying out any tasks on the tool! Protect yourself from being injured by sharp blades. Wear appropriate protective gloves when fitting and testing the blade. Before replacing the blade, make sure that it is free of any cutting residue (e. If necessary, clean out the saw blade mounting recess with a thin paintbrush or by compressed air. Unscrew the hexagonal socket head screw using the supplied hexagonal socket screw key. Feed the saw blade between the plunger and the clamp plate . [. . . ] Tips: Sågblad för trä : TPI = teeth per inch = antal tänder per 2, 54 mm Mått : 150 x 19 x 1, 25 mm, 3 TPI Bäst lämpat för: Såga i grovträ upp till 100 m i snabba snitt, även för böjda snitt eller snitt inifrån. This piece of equipment is covered by a 3-year warranty as of the date of purchase. The equipment was produced with the greatest of care and underwent thorough testing before delivery. In the unlikely event of detecting a functional defect, please return the equipment in its original packaging with the proof of purchase to the closest service address. [. . . ]