User manual KOMPERNASS PARKSIDE PHLG 2000 SE HOT AIR GUN

[. . . ] L Technical information 230 V ~ 0 Hz Setting 1: 1000 W Setting 2: 2000 W Setting 1: 300 l / min, Setting 2: 00 l / min Setting 1: 37°C, Setting 2: 0°C II / & 70 dB (A) Nominal voltage: Power consumption: Air flow approx. : Temperature Nozzle outlet approx. : Protection class: Sound pressure level: Proper use The hot air gun is intended for the removal of paint, for warming (e. g. heat-shrinkable sleeves) and for reshaping and welding of plastics. It may also be used for detaching glued connections and for defrosting or thawing water pipes. It is not suitable for defrosting pipes made from PVC or similar materials. [. . . ] J Do not look directly into the opening of the hot air nozzle E. J J In addition, you should never leave the device working unattended. Bear in mind the high rate of heat generation. If the device is not used carefully, it can give rise to increased risk of fire or explosion. Do not work in the vicinity of easily ignitable If danger arises, pull the mains plug immediately out of the mains socket. J Never use the device for a purpose for which it was not intended. J When taking a break from your work, before carrying out any tasks on the device itself (e. g. changing the nozzle) or when you are not using the device, always pull the mains plug out of the mains socket. J Do not direct the device at the same spot for too long a period. J Do not hold the nozzle outlet too close to the workpiece or the surface on which you are working. If the airflow is constricted it can lead to overheating of the device. J Always keep the device clean, dry and free of oil or grease. J Be aware of areas other than the one you are directly working on. The heat can reach inflammable materials that may be outside your field of view. Always watch what you are doing and proceed with caution. Do not use the device if you cannot concentrate or you are feeling unwell. L Operation L Preparing the device for use J The mains voltage at the mains socket must match that shown on the rating plate on the device. Devices marked with 230 V can also be operated at 220 V. GB/IE 7 Operation Caution!When using the device, never allow the ventilation slots to be covered. Switching on the device: j Press the ON / OFF switch W into setting , , I" or , , II". Switching off the device: j Press the ON / OFF switch W into setting , , 0". Setting the air flow and temperature: j The ON / OFF switch W has two different air flow settings. You can select the combination of air flow and temperature most suitable for your task. [. . . ] Wax removal: j You can remove wax residues from skis / snow board or from candle holders. Use the amount of care appropriate to the product. L Information L Service Details of the Service Centre responsible for your region are shown in the warranty documents. L Declaration of conformity / L Cleaning j j j Before carrying out any tasks on the device itself, pull the plug from the mains socket. Never use petrol, solvents or cleaning agents as these may attack the plastic. Producer We, Kompernaß GmbH, Burgstr. [. . . ]