User manual KONICA MINOLTA 9830

[. . . ] Konica T. 38 User's Guide Every effort has been made to ensure that the information in this guide is complete, accurate, and up-to-date. assumes no responsibility for the results of errors beyond its control. also cannot guarantee that changes in software and equipment made by other manufacturers and referred to in this document will not affect the applicability of the information in it. Mention of software products manufactured by other companies does not necessarily constitute endorsement by Konica Business Technologies, Inc. [. . . ] 4 At the prompt, enter the TCP Port Nos. The default setting for the TCP Port is 50200. The default password is IPFAX IPFAX is all uppercase, single byte characters. Passwords must be single byte characters. The T. 38 device is now installed to the Console Software. 7 8 T. 38 User's Guide | 31 Status Screen The Status screen displays the status of the following items · Device Mode · Communication (channel status) · LAN · Alias Address · IP Address Device Mode Operation indicates operation mode Install indicates install mode Communication (channel status) Line closed: the line can't be used. Idling: the line can be used and no communication is occurring. Sending: the line is being used and the device is sending. Arriving: the line is being used and the device is receiving Communicating: the line is being used and communication is in progress using IPFAX line. LAN Usable: the LAN may be used for communication Unusable: the LAN may not be used for communication Alias Address Displays the alias address. Refer to the "Gatekeeper" section of this T. 38 information. IP Address Displays the IP Address. 32 | Konica FAX 9930 Screens The IPFax Console Software has two types of screens for working with the network settings of a T. 38 device. · Display Screens · Change Screens The Display Screens allow you to view the settings. You cannot change the settings from this screen. The Change Screens allow you to change the network settings. Both the Display Screen and the Change Screen show the same settings for · Network · Gatekeeper · Address Table To access the screens, run the IPFax Console Software, connect to the T. 38 device you want to work with, and click on either Set Display or Set Change. Display Screen Clicking on Cancel closes the screen. Clicking on Save saves the setting values to a PC file and then closes the screen. Change Screen Clicking on OK implements any changes you have made and then closes the screen. Clicking on Cancel closes the screen without saving any changes you have made. Clicking on Save saves the setting values to a PC file, implements any changes you have made, and then closes the screen. Clicking on Read from a File allows you to display the settings previously saved to a PC file. T. 38 User's Guide | 33 Network Settings List The settings shown on the Network Settings Display and Change Screens are: Host Name MAC Address Use DHCP IP Address Default Gateway Subnet Mask TCP Port No. Value (Sec) T38 Transmission Speed Explanation Host Name The default setting is OKIFAX5950. The host name may be up to 32 characters long. [. . . ] To identify the versions of the device programs and the console software, 1 Start the IPFax Console software. On the desktop, select Start ­ Programs ­ IPFAX console. 2 Connect the software to the T. 38 device you want to work with. 4 From the drop down menu, select Version Information. [. . . ]