User manual KONICA MINOLTA BIZHUB 160 161 UM 1.1.0

[. . . ] 160/161 User Manual x Contents Contents 1 Introduction 1. 1 Safety information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-3 Warning and precaution symbols . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-4 Meaning of symbols . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-4 Disassemble and modification . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Precautions for loading paper into the automatic document feeder The following types of originals are not suitable for use in the automatic document feeder, as a misfeed or damaged original could result. Place such types of originals on the original glass. - Typing paper, paraffin paper, and other thin paper - Cards - Originals larger than Legal L or smaller than Half Letter - OHP transparencies, translucent paper - Wrinkled, dog-eared, curled, or torn originals - Clipped or stapled originals - Coated originals such as carbon-backed paper - Up to 19 A4-size document pages can be scanned and stored in the memory at one time. However, if the optional expansion memory is installed, up to 180 scanned pages can be stored. bizhub 160/161 2 3-25 3 Before making copies Loading originals into the automatic document feeder 7 CAUTION Paper jam in fact of overloaded automatic document feeder. % A maximum of 50 document pages can be loaded. % Do not load so many pages that the top of the stack is higher than the mark. % Be sure to adjust the document guides so that they are against the edges of the document, otherwise the document may not be fed in straight. 1 Place the stack of originals face up on the automatic document feeder tray. 2 3 Slide the front adjustable document guide plate to the size of the originals. For details, refer to "Making a basic copy" on page 4-3. 4 Press the [Start] key. This will start the copy cycle. 3-26 bizhub 160/161 Before making copies Placing the original on the original glass 3 The method for positioning the original differs depending on the type of original being used. Care should be taken when positioning the following types of originals. - An original of a non-standard size: The document size cannot be detected automatically. Press the [Paper] key or the [Zoom] key, and then select the desired paper size (p. - A highly transparent original (OHP transparencies, translucent paper, etc. ): Place a blank sheet of paper of the same size over the original. - A book or other three-dimensional object: Let the machine scan the contents of the original with the original cover or the automatic document feeder raised. Do not attempt to push the original glass with excessive force, as a malfunction could result. The maximum load resistance of the original glass is 2 kg. 7 CAUTION Bright light can blend your eyes. % While scanning a thick book or other three-dimensional object with the automatic document feeder or original cover open, do not look directly at the bright light that may shine through the original glass. Although the light that shines through the original glass is bright, it is not a laser beam and, therefore, is not as dangerous. bizhub 160/161 3-27 3 Positioning a sheet original Before making copies Use the following procedure to position plain paper or an original that is not suitable for use in the automatic document feeder. 1 2 Raise the automatic document feeder or original cover. Place the original face down on the original glass. 3 Position the original on the original glass so that the corner of the original aligns with the arrow in the upper-left corner of the original scales. Gently lower the automatic document feeder or original cover. For details, refer to "Making a basic copy" on page 4-3. This will start the copy cycle. 4 5 6 3-28 bizhub 160/161 Before making copies Positioning highly transparent originals 3 When making a copy from OHP transparencies, translucent paper, or other highly transparent original, position the original as detailed below. 1 2 Raise the automatic document feeder or original cover. [. . . ] 1-27 Paper length . . . . . . . . . . . . . . . . . . . . . . . . . . 1-28 Paper selection . . . . . . . . . . . . . . . . . . . . . . . . 4-5 Paper sizes . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7-9 I Image density . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ]