User manual KONICA MINOLTA DYNAX MAXXUM 3XI

[. . . ] Do not expose batteries to fire, high temperatures, water, or moisture. Do not attempt to recharge, short, or disassemble batteries. Do not store batteries near or in metallic products. Do not mix batteries of different types, brands, or ages. [. . . ] Single-frame advance - to take a single image each time the shutter-release button is pressed (p. Self-timer - to delay the release of the shutter by approximately ten seconds. Continuous advance - to take a series of images when the shutter-release button is pressed and held (p. Remote control - to release the shutter from up to 5m (16. 4ft. ) away with the optional Remote Control RC-3 (p. Date model only. 32 ADVANCED OPERATION SELF-TIMER NOTES When the shutter-release button is pressed partway down, focus and exposure are locked for the picture; confirm focus lock with the viewfinder focus signal (p. Do not stand directly in front of the camera when pressing the shutter-release button. To change the focus point, release the shutter button and then press it partway down again. Press the shutter-release button all the way down to start the timer. The self-timer indicator on the data panel blinks and the flash fires four times before the shutter releases. To cancel the self-timer countdown, change the position of the function dial. The self-timer drive mode is canceled after the picture is taken. Attach the eyepiece cap if a bright light source is behind the camera (p. 35). CONTINUOUS-ADVANCE NOTES The maximum frame rate with continuous advance is 1. 7 frames per second with a shutter speed of 1/250 or faster, no flash, single-shot AF or manual focus, fresh batteries and no date imprinting. For more information on these and other accessories, contact your Konica Minolta dealer. 35 FUNCTION DIAL The function dial controls many of the cameras creative functions and camera operations. For descriptions of the functions, refer to the appropriate sections. 47) Exposure bracketing / Multiple exposure (p. 52) (Date model only) Date and time setup (p. 18) (Date model only) Many of the functions are changed with the same operation. With the function dial in the appropriate position, press and hold the function button (1) and turn the control dial (2) to change the setting. Refer to the following sections for a description on the specific operation. 2 1 Camera Notes Except for the date imprinting function in the date model and the manual ISO settings, any changes made with the function dial are reset when using full-auto program or subject programs. 36 ADVANCED OPERATION ABOUT FULL-AUTO PROGRAM Full-auto program completely automates the picturetaking process. When the function dial is turned to or from this position, the following are reset: Flash mode (p. 48) Autoflash Wide focus frame AF Single-frame advance P 0. 0 Off Off EXPOSURE WARNING - PROGRAM When using full-auto program, subject programs, or program exposure, if the required exposure is beyond the shutter speed and aperture range, the shutter speed and aperture displays blink on the data panel. One of the viewfinder exposure indicators blink to show if the displayed exposure will cause underexposure (<) or overexposure (>). In bright conditions, use a neutral density filter on the lens, load a slower film, or, if using artificial lights, reduce the intensity of the illumination. [. . . ] · To clean the lens surface, first brush away any dust or sand then gently wipe the lens with a cloth or tissue designed for optics. · Never place lens fluid directly on the lens. · Never touch the interior of the camera, especially the shutter and mirror, doing so may impair their alignment and movement. · Dust on the mirror will not affect the exposure but may affect the focus. [. . . ]