User manual KONICA MINOLTA DYNAX 7000I

[. . . ] Using accessories or equipment not endorsed by Konica Minolta may result in unsatisfactory performance or damage to the product and its accessories. Konica Minolta is a trademark of Konica Minolta Holdings, Inc. DiMAGE is a trademark of Konica Minolta Camera, Inc. Apple, Macintosh, and Mac OS are registered trademarks of Apple Computer Inc. Microsoft and Windows are registered trademarks of the Microsoft Corporation. [. . . ] Unlike conventional TTL flash metering, ADI is not influenced by the reflectance of the subject or background ensuring optimum flash exposures. Pre-flash TTL - calculates flash exposure with a pre-flash only. This mode must be used when using close-up filters or filters that reduce the amount of light entering the camera such as neutral density filters. Pre-flash TTL must be used when a diffuser is attached to the built-in flash or an external flash unit. The camera will automatically switch from ADI metering to pre-flash TTL when a low-contrast subject is preventing the autofocus system from focusing. If the autofocus system cannot lock on the subject, use manual focus; the ADI metering will remain in effect. Manual flash control - fires the flash at full power, 1/2, 1/4, 1/8, or 1/16 power. Because no pre-flash is used, it can be used to fire slave flash units. Manual flash cannot be used with red-eye reduction or wireless. 1 2 Power ratio Select the manual option from flash control in section 1 of the recording menu. With the built-in flash raised, press the exposure compensation button (1). Use the rear control dial (2) to select the manual flash power ratio; the front control dial compensates the ambient exposure. To cancel the exposure lock, press the AEL button again. Exposure is determined with the spot metering area. Press and hold the AEL button to lock the exposure; the spot circle is displayed. The exposure remains locked until the AEL button is released. Exposure is determined with the spot metering area. Press and release the AEL button to lock the exposure; the spot circle is displayed. To cancel the exposure lock, press the AEL button again. AE toggle AE hold AE toggle These menu options do not affect the operation of the manual shift function (p. 56). 94 Recording menu Recording Mode Reset The recording mode functions can be reset in section 1 of the recording menu (p. When selected, a confirmation screen will appear; choosing "Yes" resets the following functions and settings, "No" cancels the operation. Exposure compensation Flash compensation Drive mode Anti-shake White balance White-balance shift Metering mode Contrast compensation Color-saturation compensation Filter Focus area Flash mode Flash control Sharpness 0. 0 0. 0 Single-frame advance On Auto 0 Multi-segment 0 0 0 Wide focus frames Fill flash or red-eye reduction1 ADI Normal p. p. 59 59 61 37 70 70 69 79 78 79 33 86 92 97 1. The flash mode is reset to whichever of the two modes was last set. [. . . ] · Before shipping your camera or charger for repair, please contact a Konica Minolta Service Facility. 171 Notes 172 Notes The following marks may be found on the product: This mark on your camera certifies that this camera meets the requirements of the EU (European Union) concerning interference causing equipment regulations. CE stands for Conformité Européenne (European Conformity). FCC Compliance Statement Declaration on Conformity Responsible Party: Konica Minolta Photo Imaging U. S. A. Address: 725 Darlington Avenue, Mahwah, NJ 07430 Digital Camera: DiMAGE A2 Tested To Comply With FCC Standards FOR HOME OR OFFICE USE This device complies with Part 15 of the FCC Rules. [. . . ]