User manual KONICA MINOLTA HD-501 UNPACKING/SET-UP INSTRUCTIONS

[. . . ] Turn off the machine and unplug the power cord from the machine. Remove the lower rear cover (seven screws). 3. Remove the upper rear cover (five screws). 4036U005AA 4036U006AB 4025U058AB 4036U001AA 4 5 6 4. [. . . ] Insert the cable furnished with the hard disk into the pin portion of the hard disk. NOTE Attach it regarding the side A indicated in the left figure as the reference although the cable has no directivity. (This means that the four pins on the other end of the hard disk are not used. ) Hard Disk 4036U011AB Unused four pins NOTES · Do not twist the connector 180° when you connect the cable. · When you remove the cable from the board, pull it out straightly by your hands so as not to bend the pins. Reinstall the shield cover (twelve screws). Reinstall the right rear cover (four screws). Reinstall the upper rear cover (five screws). Reinstall the lower rear cover (seven screws). 3. Remove the four screws fixing the control board assy. 4036U012AA ­2­ HD-501 I Setting the Hard Disk 1. Plug the power cord into the machine and turn on the machine. (For details of how to display the Tech. Mode screen, see the Service Manual. ) 4036P031CA 9. * Since the hard disk is yet to be formatted, the malfunction code "C-12CC" will appear. NOTE Whenever the hard disk has been installed, be sure to turn off and then turn on the machine. Failure to do this results in the machine failing to recognize that the hard disk is installed. 3. Touch "Hard Disk. " 4025P031CA 4036P034CA 5. [. . . ] Touch "Memory/Hard Disk Adjust. " 8. Turn off, and then turn on the machine. 4036P036CA 4. Touch "Hard Disk Format. " 4036P037CA 5. [. . . ]