User manual KONICA MINOLTA KN-304-QSG EJ

[. . . ] KN-304 Quick Configuration Guide Please make sure to read this Quick Configuration Guide prior to use. s Introduction q Features of the KN-304 The Konica KN-304 Network Board (to be referred simply as the KN-304) is a network interface board for the Konica IP-011 printer controller. Installing the KN-304 in the IP-011 printer controller enables the Konica 7020 to be used as a network printer. Request installation of the KN-304 to your Konica service representative. The KN-304 offers the following features: · Automatic Selection of 100Base-T (Fast Ethernet) or 10Base-T · Supports peer-to-peer printing by TCP/IP from Microsoft Windows 95 or 98 (by using a dedicated utility) · Supports lpr/lpd on TCP/IP for Microsoft Windows NT 4. 0 or later (to be referred to as Windows NT/ 2000*) *Windows 2000 will be available in the future. [. . . ] Do not change this except under special circumstances. [Description]: A character string is entered for the purpose of explanation. This character string is displayed after the port number when selecting the printing destination port in setup of the printer driver. English q Printer Driver Installation After IP peer-to-peer setup is completed, install the "Konica IP-011 nozomi" printer driver. The printer driver installation procedure is described below. Insert the CD-ROM containing the printer driver into the CD-ROM drive and double-click on [Setup. exe] in the [95nozomi] folder to start up the installer. Proceed with installation by following the instructions displayed on the screen. Select [Local] for the printer connection format. In addition, select the printer name set with the IP peer-to-peer program for the printer port. In addition, the "Konica IP-011 Printer Tool" cannot be used. These printer tools are provided for parallel connection. Once installation is completed, although the program will then ask if Windows is to be reset immediately, since it is not particularly necessary to reset Windows, select "No" and then click on the [Finish] button. KN-304 Quick Configuration Guide 5 s When Using in an Environment Consisting of Windows NT and Windows 95/98 Printing can be performed using TCP/IP printing service (lpr) from a computer compatible with Windows NT. The setup procedure in this case is as described below. Set up TCP/IP of the KN-304 from the LCD panel of the Konica 7020. Set up TCP/IP on the computer being used (Windows NT). Install "Microsoft TCP/IP Printing" if it is not already installed. Add the printer port and install "Printer Driver". q TCP/IP Setup of KN-304 (Printer) Refer to "q TCP/IP Setup of KN-304 (Printer)" on page 4. q Installation of Microsoft TCP/IP Printing Service When [Network] is selected from the [Control Panel] of a computer compatible with Windows NT, the [Network] dialogue box is displayed. Click on the [Services] tab and confirm that [Microsoft TCP/IP Printing Service] is present in the [Network Services] list. If [Microsoft TCP/IP Printing Service] is not on the list, add it to the list. Refer to the Windows NT help menu for information on the procedure for adding Microsoft TCP/IP printing. q Addition of Printer Port and Installation of Printer Driver Once installation of Microsoft TCP/IP Printing Service has been completed, perform addition of the printer port and installation of the "Konica IP-011 nozomi" printer driver. This procedure uses the [Add Printer] function of Windows NT. In addition, a CD-ROM is required that contains a printer driver. [. . . ] In addition, it is necessary that an IPX protocol be set up to search for a KN-304 using IPX. q MAP Installation The procedure for installing MAP is as described below. Insert the CD-ROM into the CD-ROM drive and double-click on [Setup. Check the screen display and then click on the [Next] button. Check the folder in which MAP is to be installed. [. . . ]