User manual KONICA MINOLTA LT-203 LT203 SERVICE MANUAL

[. . . ] SERVICE MANUAL MODEL LT-203 Large Capacity Tray Unit NOVEMBER 2002 CSM-LT203 LT-203 SERVICE MANUAL Used On Model 7145 November 2002 IMPORTANT NOTICE Because of the possible hazards to an inexperienced person servicing this equipment, as well as the risk of damage to the equipment, Konica Business Technologies strongly recommends that all servicing be performed by Konica-trained service technicians only. Changes may have been made to this equipment to improve its performance after this service manual was printed. Accordingly, Konica Business Technologies, Inc. , makes no representations or warranties, either expressed or implied, that the information contained in this service manual is complete or accurate. It is understood that the user of this manual must assume all risks or personal injury and/or damage to the equipment while servicing the equipment for which this service manual is intended. Corporate Publishing Department © 2002, KONICA BUSINESS TECHNOLOGIES, INC. [. . . ] Stick the seal [4] to the detection reel [1]. For reinstallation, follow Steps 1 to 8 in "A. Removing the wire" in reverse order. [6] [5] [11] [12] [2] [1] [4] [3] 3-13 III DIS. /ASSEMBLY around the pulley [7] and install it to the spring PAPER FEED SECTION Note: · After finishing wire replacement or rewiring, move the paper lift plate up and down by hand to confirm that moves smoothly. · Make sure that the wires do not cross each other, or a wire does not run on another wire. · After installing the wires, adjust "LT tray tilt adjustment". III DIS. /ASSEMBLY 3-14 PARTS CATALOG Model LT-203 DECEMBER 2002 KONICA BUSINESS TECHNOLOGIES, INC. How to use this catalog This parts catalog includes illustrations and part numbers for all replacement parts and assemblies used in this model. Model-specific parts are identified in the illustrations with reference numbers. Use the reference number to locate the corresponding part number on the facing page. Common hardware items, such as screws, nuts, washers, and pins, are identified in the illustrations with reference letters. Use the reference letter to locate the corresponding part number on the hardware listing in the lower right hand corner of the facing page. If you know a part number, but don't know where the part is used, use the numerical index to determine the page number and reference number for that part. Because some common parts are used in several places, there may be more than one entry. Refer to the illustrations to see where the part may be used. If you know a part's description, but don't know where to look to find the part number, use the alphabetical index to determine likely page and reference numbers. Then look at the illustrations to determine that you have identified the correct part. Locate the part number using the listing on the opposite page. Retail pricing that appears with the numerical index, while valid when this catalog was printed, is subject to change without notice. The prices are only suggested prices and are provided only for reference. Dealers may determine their own selling prices. For up-to-date pricing, refer to current Konica price lists or contact the Konica Parts Distribution Center. How to order parts Use standard Konica parts ordering procedures to obtain these parts. For ordering options, contact Konica's Parts Distribution Center. When ordering parts, be sure to specify part numbers exactly as listed in this catalog. [. . . ] (S tight screw M3 x 8: 2 pcs. ) After fixing, pull the slide rail all the way to the front until it stops at the stopper. Connector location of connection S-tight screws M3x8 (5) Align the relay wires fixing plate with the projection and install with the two screws (TP screw M3 x 6: 2 pcs. ). (1) Insert the slide rail to the lower installation guide on the LCT left side. (2) Install the slide rail to the LCT installation guide using the screws. (TP screw M4 x 6: 2 pcs. ) Caption : Check the degree of parallel of the slide rail and the LCT installation guide. [. . . ]