User manual KONICA MINOLTA MAGICOLOR 2300W

[. . . ] magicolor 2300W User's Guide ® 1800727-001A Thank You Thank you for purchasing a KONICA MINOLTA printer. Trademarks The KONICA MINOLTA and KONICA MINOLTA logo are trademarks or registered trademarks of KONICA MINOLTA HOLDINGS, INC. magicolor is a trademarks or registered trademarks of KONICA MINOLTA PRINTING SOLUTIONS U. S. A. , INC. Other trademarks and registered trademarks are the propery of their respective owners. Acrobat ® Reader Copyright © 1987-2002 Adobe Systems Incorporated. [. . . ] Do not duplex custom-sized media, envelopes, labels, thick stock, or transparencies. Recheck the media path inside the duplex unit and make sure that you have removed all of the jammed media. Duplex The wrong media is option jams. being used. Solving Problems with Media Jams 81 Symptom Media is jamming. Cause Solution Remove the jammed media and The media is not correctly positioned in reposition the media properly in the tray. The number of sheets Remove the excess media and reload the correct number of sheets in the in the tray exceeds tray. The media guides are Adjust the regulation guides in the tray not correctly adjusted to match the size of the media. Warped or wrinkled Remove the media, smooth it out, and media is loaded in the reload it. If it still jams, do not use that media. Remove the moist media and replace it with new, dry media. Load the transparencies or labels The recommended transparency (OHP) according to the manufacturer's instructions. or label paper is facing the wrong way in Tray 1. Envelopes are facing Load the envelopes in Tray 1 so the flaps are facing down. If the flaps are on the short edge, set the envelopes in Tray 1 so that the flaps are on the printer side. Remove the OHP media and load it in Multiple sheets of transparency (OHP) the tray one sheet at a time. Do not fan media are collecting transparencies before loading them. Unsupported media Use media that is covered by the printer warranty. (wrong size, thickness, type, etc. ) is being used. Media supply roller is Clean the media supply roller. For more details, refer to "Media Rollers" on page 66. 82 Solving Problems with Media Jams Solving Other Problems Symptom Cause Solution The power cord is not Turn the power switch off (O position), Printer power is not correctly plugged into then remove the power cord from the outlet and plug it back in. Something is wrong with the outlet connected to the printer. The power switch is not correctly turned on (I position). Plug another electrical appliance into the outlet and see whether it operates properly. Set the power switch to the off (O) position, then set it back to the on (I) position. Use a power source with the The printer is specifications listed in appendix A, connected to an outlet with a voltage "Technical Specifications. " or frequency that does not match the printer specifications. An error message is Data was displayed in the sent to the printer, but it Status Display. [. . . ] Remove from the power cord from the socket with wet hands as this may result in an electric shock. Place any heavy objects on the power cord. Do not pull or kink the cord as this can result in damage to the cord. The result could be an electric shock or a fire. [. . . ]