User manual KONICA MINOLTA MICROSP 2000L MICROSP2000L OPERATOR MANUAL

[. . . ] In this manual, the Toolbar icon will be displayed alongside the description for a command that is available on the Toolbar. File The File menu contains commands for manipulating files and for exiting the OPC program. The following sections explain these commands and their usage. Add To add files to the OPC File List Window: 1. Select File from the OPC main menu and select Add. [. . . ] Select File from the OPC main menu and select Add. Select the location of the files to be added. Select the files to add. OpenPrinterTM Connection Reference Manual 5 4. The selected files will be displayed in the OPC File List Window. OPC sorts files in alphanumeric order. Adding a PSM job into the OPC File List window does not actually make a copy of the PSM job. A link is created that references the PSM job. Print Print will send the selected file(s) to any of the laser printers available locally or on the network. 6 OpenPrinterTM Connection Reference Manual Getting Around in OPC When selecting multiple files remember -- all of the selected jobs must be of the same type. Mixing jobs, for instance, that are A4, and Ledger will not work. The correct paper size must be chosen for each job type, even when using the Optimized mode. In the File List window, select the files to print. Select File from the OPC main menu and select Print. Standard mode will cause printing time to be slower in some cases. Optimized - Optimized must be given information to print correctly. When selecting Page Orientation on the Print Properties dialog (in Optimized mode) follow these rules: a. Long Edge Feed paper ­ select Landscape b. Short Edge Feed paper ­ select Portrait · Print time may be reduced when printing Long Edge Feed paper in Optimized Mode To choose the printing mode: 1. Determine what is known about the job to be printed. As stated above, if little is known about the job, Standard mode should be used. Select Settings from the OPC main menu and select Mode. Select either Standard or Optimized from within Mode. Image Offset If for some reason the printed page is not aligned correctly, the Image Offset dialog may be used to correct the placement. The Units available for entering the offsets are: · Pixels · Millimeters · Inches Image Offset is not available when Use CCITT G. 4 Print Accelerator is enabled. Use CCITT G. 4 Print Accelerator (Compression) The setting Use CCITT G. 4 Print Accelerator may be used when the Xionics XipPrint II card is installed in the target printer. [. . . ] Select either Standard or Optimized from within Mode. Image Offset If for some reason the printed page is not aligned correctly, the Image Offset dialog may be used to correct the placement. The Units available for entering the offsets are: · Pixels · Millimeters · Inches Image Offset is not available when Use CCITT G. 4 Print Accelerator is enabled. Use CCITT G. 4 Print Accelerator (Compression) The setting Use CCITT G. 4 Print Accelerator may be used when the Xionics XipPrint II card is installed in the target printer. The Xionics XipPrint II is an optional hardware item. Contact T/R Systems or your MicroPress dealer for information on obtaining and installing the XipPrint II. OpenPrinterTM Connection Reference Manual 9 Using and enabling the XipPrint II card will greatly improve spooling and printing times. [. . . ]