User manual KONICA MINOLTA MICROSP 3000 MICROSP3000 OPERATOR MANUAL

[. . . ] Never use flammable sprays, liquids or gases near the machine. Never modify the machine, as a fire or electrical shock could result. Never remove any panel or cover which is secured. The machine contains high voltage components which can cause electrical shock. [. . . ] When AutoMasking, Trimming, or Masking are set to off, AutoMasking will automatically be enabled when Centering is selected. Centering: Places a screen image that had been searched using Automasking or an image that has been trimmed in the center of the page. Fit: Enlarges a screen image that had been searched using Automasking or an image that has been trimmed to fit the page. The maximum percentage of enlargement is 2. 00x. When the image on the screen is Letter size and Fit is used, it will be printed using the lowest level of magnification as shown below. Letter: 1. 00x Legal: 1. 00x Ledger: 1. 30x * Centering and Fit are disabled when Masking selected. Control Panel Keys and Indicators Masking Key: When pressed, this key rotates from OFF to the Auto, Trimming or Masking functions. Auto Masking: The Auto Masking function will omit the frame (non-image area) of a printed film image. · The previous Centering/Fit setting is applied whenever ON is selected from the OFF state. · If OFF is selected from the ON state, Centering/Fit is disabled. * Auto Masking is not applicable with the Masking or Trimming settings. Indicates the current density level of the printed image. Auto Exposure mode is indicated when the green Auto light is on. The green Auto light turns off when the Scanner is in the Manual Exposure mode. Shows the number of prints set to be made. Also displays corresponding codes in the event of a malfunction or paper misfeed. The blinking number in this display indicates a print cycle in progress. Blinks when the Imaging Cartridge or Toner Cartridge of the Printer is running out of toner and lights up when the cartridge has completely run out of toner. Exposure Mode Key: Exposure Display: Exposure Mode Indicator: Multi-Print Display: Add Toner Indicator: Scanner Chapter 2 2-10 3. Control Panel Keys and Indicators Memory Input Key: To store one of the following functions into the memory of the Scanner, first set one of the functions on Control Panel and then press this button with the head of a pen or other device. The next time the scanner is turned ON, that function will appear as a default setting until a new one is entered. 1) Negative or positive Chapter 2 2) Print mode 3) Output Format 4) Print image density 5) Exposure mode Scanner 6) Centering or Fit 7) Masking 8) Auto Skew Correction 9) Horizontal Area setting 10)Vertical Area setting NOTE If you do not press the pinhole for at least 60 seconds after a setting has been made with the Auto Reset function set to ON, the previous setting remains valid. Clear/Stop Key: Multi-Print Keys: Press to clear the setting on the Multi-Print Display, resetting it to "1" or to stop a multi-print cycle. [. . . ] Outline Emphasis: applied when film contains blurred black and white images. Disabled 30 min. Contrast Emphasis Outline Emphasis Fine mode contrast select 4-5 2. Initial Settings List System Settings Auto Skew Correction Retain Machine ID Printing Description Determines whether or not to retain the original (uncorrected) skew of a screen image after the print has been made. Selection Retained Not retained Disabled Pattern 1 Pattern 2 Initial Setting When two scanners are connected to one printer, this function leaves an identifica(MicroSP 2000 H tion marker on the print so that the scanner used for the job can be determined System only) after printing. Pattern 1 Pattern 2 Paper Paper Cycle print mode This function automatically scans the next image following a preset period of time (the period can be set by an authorized dealer). [. . . ]