User manual KONICA MINOLTA PS3000 OM

[. . . ] Operator's Manual PS3000 Operator's Manual INTRODUCTION Thank you for choosing the Minolta DPCS3000 (PS3000 + Di30). This users manual explains the various functions provided by the DPCS3000. It also gives some maintenance as well as troubleshooting tips. Before operating this system, read this manual carefully until you familiarize yourself thoroughly with its operation and features. [. . . ] If an arm is inside this space, the system will be unable to make a good copy. 30 mm NOTE If your finger or hand gets in the area shown at left when holding the book, the Scanner may not be able to read the data correctly. NOTE If the book original is so thick that its use in the Spread mode results in the warning, select the Page-by-Page mode and bring each of the two pages into the auto focus range separately for making page-by-page copies. 3-9 PS3000 Operators Manual Chapter 3 How To Make Copies You can select the copying area, if you make a copy of whole area (two pages) of a original or only one side (left or right page) of the original, by the Spread Key and the Page-by-Page Key. A lit LED or LEDs behind the open-book graphic symbol in each Start Key tell the area of original to be copied. Spread Spread: The verso (left) and recto (right) pages of the open book are copied onto a single sheet of paper. Left Start Key Right Start Key Page-by-Page: Each of the verso (left) and recto (right) pages of the open book is copied onto a separate single sheet of paper (verso only or recto only). Check that the Display Panel tells that the system is ready to make copies. (The message should be shown on the panel. ) Page-by-Page 2. Place the original face up on the Original Table. (See Placing the Original on p. 3-7 and Notes on Originals on p. 3-5. ) 3. Adjust the height of the right- and lefthand sides of the Original Table so that the top surfaces of the two pages of the original level off, as visually checked. 3-10 PC3000 Operator's Manual Chapter 3 4. Example 1: To make a page-by-page copy of the recto (right) page of an open book or a sheet original, check that the message and lit Start Key are as shown in A at left and then press the right Start Key. Example 2: To make a spread copy on a single sheet of paper of the recto (right) and verso (left) pages of an open book or a sheet original, check that the message and lit Start Key are as shown in B at left and then press either the right or left Start Key. 5. The lamp lights up with full intensity and the Scanner starts reading the data on the original. At this time, the Display Panel shows the message, the Start Key or Keys light up orange, and the Original Table is locked. 6. The lamp then lights up with half intensity and the Start Key or Keys turns green. This indicates that the Scanner has completed reading the data. At this time, the Original Table is unlocked. NOTE If Warn of Set is set, a buzzer sounds and a warning is given on the Display Panel if the Scanner is unable to read the data correctly when the Start Key is pressed. The reading sequence is interrupted at this time. 3-11 PS3000 Operators Manual Chapter 3 Types of Copy The system allows you to make three different types of copy. Spread Copy The system copies the image of the original symmetrical around the center of the Original Table onto a single sheet of copy paper. Press the Spread Key to select this mode. When the key is pressed, its LED lights up green. 1 2 1 2 Page-by-Page Copy The system copies each page of the original determined with reference to the center of the Original Table onto a single separate sheet of paper. This mode can be selected with the Pageby -Page Key. When this key is pressed, its LED indicating the page to be copied lights up green. 1 PushLeft Start Key 2 PushRight Start Key 1 2 Book Split Copy 1 PushLeft Start Key 2 PushRight Start Key 1 2 1 The system copies each page of the original determined with reference to the center of the Original Table onto a single separate sheet of paper, consecutively from the verso to recto page, or vice versa. The page for which the Start Key is pressed becomes the first copy, the opposite page the second copy. [. . . ] 3-5 to 3-6 and change the settings to suit the type of original being used. The height of the surface of the original is more than 50 mm above the Original Table. A tag or bookmark is on the book original. The book original is outside the size lines on the Original Table. Book expousure level is too high The image density of the entire original surface is high. Book size is not found A tag or bookmark is on the book original. 5-2 PS3000 User's Manual Chapter 5 Warning Message Possible Cause The book original is outside the size lines on the Original Table. The original is placed aslant with respect to the size lines. [. . . ]