User manual KONICA MINOLTA PSNS-V12 UM 2.0.0

[. . . ] User Manual PageScope Network Setup v1. 2 www. minoltaeurope. com Foreword Welcome Thank you for using Minolta PageScope Network Setup. PageScope Network Setup is utility software which allows simple network setup of devices such as printers. It allows setup of devices on networks connected using TCP/IP or IPX protocol to be handled together. PageScope Network Setup supports the following functions. [. . . ] · The community name input dialog box appears only if the SNMP community name has been changed to something other than the default name. Type in the community name and then click OK. 14 4 Changing the Device Setup 4. 3. 1 Setting up the Print Server Perform the following steps to set up the print server for NetWare printing. Type up to 26 characters into the Print Server Name box for the print server name. Normally, you should leave the following items set to their initial defaults. Change these settings only when absolutely necessary for some reason. Print Queue Scan Rate Type in the interval, in seconds, to specify how often the print server should check the queue. Ethernet Frame Type Specify the Ethernet frame type. After you are finished configuring the setup, click the Next button. Note · To configure a NetWare print setup, the server must be bound to at least one IPX frame. 15 4 Changing the Device Setup 4. 3. 2 Selecting the Mode Use the procedures in this section to select the server you want to configure as the print server, or the NDS context. If you are using bindery service (NetWare 3. x): 1. Put a check mark into the NetWare 3. x Bindery Server check box. Click the button to display the Mode Select dialog box, which shows a list of servers on the NetWare network. Select the server you want to configure as the print server, and then click the OK button. When everything is the way you want, click the Next button. If you are using NDS (NetWare 4. x or 5. x): 1. Put a check mark into the NetWare 4. x NDS Context check box. Click the button to display the Mode Select dialog box, which shows a list of NDS trees on the NetWare network. Select the NDS tree you want to setup as the print server, and then click the OK button. Click the button to display the Mode Select dialog box, which 16 4 Changing the Device Setup shows a list of NDS contexts for the tree you selected. Select the NDS context to setup the print server, and then click the OK button. When everything is the way you want, click the Next button. 5. 6. Note · If you are logged on to the NetWare network without supervisor privileges, the NetWare login screen will appear after you finish configuring the setup. If this happens, type in the supervisor login name and password, and then click OK. 4. 3. 3 Selecting the Print Queue Use one of the following procedures to select the print queue for the print job. To select an existing print queue: 1. Use the upper left box to select an NDS tree (in the case of NDS) or a server (in the case of bindery service). [. . . ] Enter IP addresses into the Start and End boxes, and then click the Append button. The specified IP addresses are added to the Client List box. To specify a single IP address for assigning the BOOTP server: 1. Enter an IP address into the Single box, and then click the Append button. [. . . ]