User manual KONICA K28 PRE-INSTALLATION INFORMATION

[. . . ] Graphic Imaging International 71 Charles St. , Glen Cove, NY 11542 PHONE :(516) 674-2500 FAX :(516) 674-2727 Konica K21/28/34 Pre-Installation Information To avoid waste of your production time as well as the time it will take for the engineer to install the processor, please make sure that the requirements listed below are fulfilled before you schedule the installation. ENVIRONMENTAL REQUIREMENTS Provide a heating and ventilating system capable of maintaining room temperature between 10° and 25°C (50°- 77°F) and relative humidity (RH) between 50% and 60%. [. . . ] The recommended distance from the processor to the drain is 0. 5 m max. Copper or brass should not be used in the drainage system as fixer containing silver might attack it. Therefore plastic or rubber is recommended. If silver recovery is desired, the 25 mm (1") drain hose from the fixer tank can be Connected to a silver recovery unit. CLEANING FACILITIES For cleaning purposes it would be convenient to have easy access to a water tap and a suitable sink, where racks, rollers and guides can be washed and chemicals mixed. POWER CONNECTIONS If not already there, a main power outlet should be installed in the room, where the processor will be situated. recommended distance to the processor is 2 m (6 ft). The requirements are specified in the following pages. 3/2001 K21/28/34 pre-installation info Page - 1 - Technical Specification 3/2001 K21/28/34 pre-installation info Page - 2 - 3/2001 K21/28/34 pre-installation info Page - 3 - 3/2001 K21/28/34 pre-installation info Page - 4 - 3/2001 K21/28/34 pre-installation info Page - 5 - (198V-253V) Please Note: 1. [. . . ] (If outlet is not available, the customer is to supply a plug to mate with the outlet used). Air Conditioning requirment 17, 000 Btu (Maximum) 3/2001 K21/28/34 pre-installation info Page - 6 - 3/2001 K21/28/34 pre-installation info Page - 7 - 3/2001 K21/28/34 pre-installation info Page - 8 - [. . . ]