User manual KORG BX3 2

[. . . ] E 2 IMPORTANT SAFETY INSTRUCTIONS 1) 2) 3) 4) 5) 6) 7) 8) 9) Read these instructions. No objects filled with liquids, such as vases, shall be placed on the apparatus. Do not block any ventilation openings, install in accordance with the manufacturer's instructions. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. [. . . ] Higher settings will increase the noise volume. 10. Press the [WRITE/ENTER] key to write the settings into internal memory. For details, refer to "Writing a program" (p. 19). 4. Move the bars of the Drawbar 1 or Drawbar 2 sections (you may use either) to adjust the drawbar parameters. Any bar you move will input a new value for that parameter, and the display will change accordingly. Press the [®] key once to display the "LOWER" parameters. Move the bars of the Drawbar 1 or Drawbar 2 sections to adjust the drawbar parameters. Press the [WRITE/ENTER] key to write the settings into internal memory. For details, refer to "Writing a program" (p. 19). Other parameters The BX-3 has other parameters that apply various effects to the sound. In the factory-set programs, these effects are set as appropriate for each sound. If you want to make detailed adjustments to the sound of a program, you can edit the following parameters in Normal Edit mode or EX Edit mode. · Percussion settings: Group 3 (p. 25) · Amp simulator settings: Group 4 (p. 26) · Reverb settings: Group 5 (p. 26) · Rotary speaker settings: Group 6 (p. 26) · Modulation wheel and pedal controller settings: Group 7 (p. 27) EX mode In EX mode, the lower keyboard will play the "EX LOWER" parameter settings that are preset in the program, regardless of the current setting in the DRAWBAR SELECT section. To edit these settings, use the following procedure. Press the PROGRAM [2] key, and then press the [®] key once. The "EX LOWER" parameters will be displayed. Use the [ ][®] keys to select a bar. You can make settings for the three bars 16', 8', and 4'. Editing the drawbar parameters When the DRAWBAR SELECT section [DRAWBAR PRESET] key is pressed, the drawbars will sound at the levels saved with the current program. These settings are saved individually for each program. 16' 8' 4' 5. Use the [-][+] keys to adjust the value. The display will show the value as you adjust it. Press the [WRITE/ENTER] key to write the settings into internal memory. For details, refer to "Writing a program" (p. 19). Normal mode If the [DRAWBAR PRESET] key is pressed in both upper and lower DRAWBAR SELECT sections, the "UPPER" parameters will be used when you play the upper keyboard, and the "LOWER" parameters will be used when you play the lower keyboard. [. . . ] Lower the organ slowly onto the stand, and do not drop it. 9. Fixer l'orgue au pupitre Placer l'orgue sur le pupitre et l'attacher par en dessous à l'aide des quatre boulons à ailettes. Lors de la mise en place de l'orgue sur le pupitre, faire attention de ne pas se coincer la main. Abaisser l'orgue lentement sur le pupitre, sans le lâcher. Wing knobs / Boulons ailettes Check after assembly · Make sure that none of the bolts are loose. Vérification après montage · Vérifier si aucune des vis ou des boulons ne sont lâches. Other cautions After assembly, please observe the following cautions. [. . . ]