User manual KORG C-320

[. . . ] Now the three realtime control knobs below the display can be used to select and adjust the model settings, such as distortion type, tone, cabinet or mic type. Pressing the [ENTER] or [YES/OK] keys allow you to select additional edit parameters. And the last edits made in modeling mode are preserved when the power is turned off. INSERT EFFECT - In this mode you can set Insert effect assignments on input or on track playback, and assign the effect type. [. . . ] Both this function and Auto-Punch are great features for "hands-free" operation when recording by yourself. SCRUB - When playback is stopped and this key is pressed, you can view track waveform data (by selecting the " " button next to "1Tr"), and using the "ZOOM" buttons ( , etc. ) to resize the waveform. Once you've selected a track, you can use the DIAL to scrub the audio. Pressing the [ ] FF key while in the scrub mode will play the audio back at half speed, one octave lower than the original pitch ­ a great feature for learning intricate solo parts from pre-recorded track data. METER/TRACK VIEW - This mode enables you to view track, effect send, and Monitor / Master output levels. You can select two different types of meter view: Pre-Fader (before the fader) and Post-Fader (after the fader), and three types of track views, which enable you to see which tracks contain recorded audio. To change the display mode, select the " " button at the top lefthand side of the display, and press the [ENTER] key. UNDO -This function allows you to go back and UNDO/REDO any previous recording or editing procedure in the current song. The D1200mkII lets you set the desired number of undo levels: 99, 8 or 1 level. Note: A setting of "8" or "1" UNDO levels allows you to conserve hard disk space. TUNER - Here you can tune an instrument connected to the INPUT 1/GUITAR jack, with the built-in auto-chromatic tuner. 4. Press the [INPUT/OUTPUT/SOLO] key. Connect your audio source (mic, keyboard L/R outputs, etc. ) to the analog inputs on the top of the D1200mkII. If you are connecting a guitar to the D1200mkII directly, use the GUITAR IN jack on the front panel. (For more information on insert effect types refer to the Owners Manual pg. To select the track where the insert effect is going to be applied, select the " " popup button in the display below "InsertTo:". Using the CURSOR and [ENTER] keys and the DIAL, select the assign channel and destination, and then press [YES/OK]. To choose an insert effect, select the "insert effect" tab for the effect that you want to change (ex. "InsEff1" for Insert Effect 1) and use the DIAL to select an effect. To edit a selected effect's parameters, select the "effect name" button in the display (ex. MM2:P4EQ-Wah ), press [ENTER] and then select the "icon" in the display to access the edit parameters. 3. 4. Press the [MASTER EFFECT / AUX] key , and rotate the DIAL to select an effect for Master Effect 1 ("MstEff1"). [. . . ] Select "ProtectSong" as the "EditType" with the DIAL off. (The "lock" icon will disappear) CURSOR down to Exec and press [ENTER] to turn protection 2. 7 D1200mkII EasyStart Bounce and Burn! 1. On the "RecMode" tab select Bounce using the CURSOR keys and press [ENTER]. On the "Bounce" tab, select 12Tr->2Tr using the CURSOR keys and press [ENTER]. [. . . ]