User manual KORG DT1

[. . . ] And, CE mark which is attached after January 1, 1997 means it conforms to EMC Directive (89/336/EEC), CE mark Directive (93/68/EEC) and Low Voltage Directive (73/23/EEC). Also, CE mark which is attached to our company’s products of Battery operated apparatus means it conforms to EMC Directive (89/336/EEC) and CE mark Directive (93/68/EEC). ) This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. [. . . ] These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • Reorient or relocate the receiving antenna. €¢ Increase the separation between the equipment and receiver. €¢ Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. €¢ Consult the dealer or an experienced radio/TV technician for help. Unauthorized changes or modification to this system can void the user’s authority to operate this equipment. Tilt slit The slit located on the back of the GA-30 is used to tilt the tuner. Place a card or similar object in the slit. Each marking in the meter scale corresponds to 2 Hz. For example if you want to tune each string of your instrument using a reference pitch of A=436 Hz, adjust the tuning of each string so that the needle indicates two steps below «440». While tuning with the onboard mic a quiet environment is recommended for precise tuning. S Sound mode In this mode you can tune while listening to a reference pitch. Press the [SOUND] switch to enter Sound mode. Press the [SOUND] switch until the note to which you wish to tune appears in the display. For the notes that can be output, refer to step 3 of «Meter mode. » When you make a complete cycle, you will return to Meter mode. - GUITAR will output a pitch that is one octave higher than the actual pitch of your instrument, and BASS will output a pitch that is two octaves higher. Listen to the pitch sounded by the GA-30, and tune your instrument accordingly. [. . . ] - GUITAR will output a pitch that is one octave higher than the actual pitch of your instrument, and BASS will output a pitch that is two octaves higher. Listen to the pitch sounded by the GA-30, and tune your instrument accordingly. Q Flat tuning You can use Meter mode or Sound mode to tune to a pitch that is lowered by ) for the specified note. 1–5 semitones ( – 1. [. . . ]