User manual KORG DTR-2

[. . . ] This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: · Reorient or relocate the receiving antenna. · Increase the separation between the equipment and receiver. [. . . ] It shows the current position of the Step Editor. To go to a different position within the Song, select this parameter, then use the TEMPO/VALUE controls, the A VOLUME/VALUE buttons, or the < > buttons (while the << >> buttons let you move to the previous or following measure). When using one of these controls, the locator moves in steps of 1/8 (192 ticks), or jumps to the next event. The locator's format is as follows: the end of the Song. To delete all Tempo Change events in the Song, go back to the M001. 01. 000 position, and press SHIFT + DELETE. Note: All events on the very first tick (M001. 01. 000), like Perf, Style, Tempo, Chord, Style Element selection, cannot be deleted. Style M001. 01. 000 Measure Beat Tick Measure: Measure or bar number. Beat: Divider in the Time Signature ratio (e. g. , a quarter in a 3/4 time). Tick: Minimal sequencer's resolution. The Pa50 internal sequencers feature a resolution of 384 ticks per quarter. INSERT When the Measure parameter is selected, press INSERT to insert a measure starting from the current position. All Chord/Acc events contained into the current measure will be moved to the following measure. To insert a Performance change at the current position, follow the standard selecting procedure using the buttons of the PROGRAM/PERFORMANCE section. Note: The STYLE CHANGE LED is automatically turned on when entering the Chord/Acc Step Mode. This means that selecting a Performance automatically selects the Style memorized into the Performance. The SINGLE TOUCH and STS buttons are automatically disabled, meaning that you can't change the Realtime (Keyboard) tracks while in Chord/Acc Step Mode. DELETE When the Perf parameter is selected, and the side arrow ( ) ­ showing that a Performance Change event has been selected at the current position ­ appears next to it, press DELETE to delete the Performance Change at the current position. Backing Sequence operating mode How to delete a whole Song 87 Note: If the side arrow doesn't appear, the event was not selected at the current position, and will not be deleted. SHIFT + DELETE When the Perf parameter is selected, press SHIFT + DELETE to delete all Performance Change events, starting from the current position to the end of the Song. To delete all Performance Change events in the Song, go back to the M001. 01. 000 position, and press SHIFT + DELETE. Note: All events on the very first tick (M001. 01. 000), like Perf, Style, Tempo, Chord, Style Element selection, cannot be deleted. SE (Style Element) cally recognized. While recognizing a chord, the status of the BASS INVERSION button will be considered. "No chord" means that the accompaniment will not play at the current position (apart for the Drum and Percussion tracks). To select the "No chord" option, press F1 to select the Name part of the Chord, then use the TEMPO/VALUE section to select the very last value (C. . . B, Off). [. . . ] Cannot save data to a floppy disk Is the disk formatted?Is the write protect tab of the disk in the protect position?Cannot load data from a floppy disk Is the disk inserted correctly?Does the disk contain data compatible with the Pa50? [. . . ]