User manual KORG DTR1000

[. . . ] Owner’s manual Thank you for purchasing the Korg DTR-2000/1000 digital tuner. To enjoy long and trouble-free use, please read this owner's manual carefully and use the product as directed. Do not block any ventilation openings, install in accordance with the manufacturer's instructions. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. [. . . ] On the DTR-2000, you can press this switch simultaneously with the CHROMATIC switch to enter Sound mode. 9 Rack installation holes As shown in the diagram, you can use the included screws, insulating washers, and insulating bushings to install the DTR-2000/1000 in an EIA-standard rack. EIA standard rack Front panel side Screw Insulating washer Insulating bushing 1 INPUT 1, 2 jacks Connect the instrument you wish to tune to these jacks. However if a plug is inserted in the front panel input jack, this jack (INPUT 1 on the DTR-2000) cannot be used. 2 OUTPUT jack Connect this jack to your amp or mixer. It will output the sound that is input from the INPUT 1, 2 jack. 3 DTR-2000 only: SOUND jack Connect this jack to your amp or mixer. in Sound Out mode , a reference tone will be output from this jack. 4 MUTE jack You can connect a latch-type (alternate-type) switch to this jack, and use it to switch muting on/off. However, this jack cannot be used if the front panel MUTE jack is being used. 5 DTR-2000 only: INPUT SELECT jack You can connect a latch-type (alternate-type) switch to this jack, and use it to switch between INPUT 1 and 2. 6 ~ACV connector (Power supply connector) Connect the included power cable to this connector. Then plug the other end into an AC outlet. Tuning procedure On the DTR-1000 you can use the tuning meter to perform chromatic tuning. On the DTR-2000 you can use the tuning meter or a reference pitch to tune in eight different modes (refer to "Tuning modes" on the following page). Tuning may not be possible if your instrument has an excessively high output level. In this case, lower the output level of the instrument that you are tuning Connections If you want to tune an electric guitar or bass, plug it into the INPUT 1, 2 jack. Use the INPUT SELECT switch to select the jack that you are using. If you want to tune an acoustic instrument, use a contact mic (CM-100: sold separately). On the DTR-2000 if you use the INPUT SELECT switch to select the unused INPUT jack and then turn Mute on, you will be able to tune using the built-in mic. If you use the internal mic, place your instrument as close to the DTR-2000's mic as possible. Also be careful that the mic does not pick up sounds other than the instrument that is being tuned. [. . . ] When you enter Sound mode, the reference tone will be "A" for Chromatic mode, or the lowest note for the other tuning modes. If you are producing sound on your instrument at the moment you enter Sound mode, the DTR-2000 will output the reference tone that is closest to that note. Tune your instrument to the reference tone. To exit Sound mode, simultaneously press the DISPLAY switch and the CHROMATIC switch. [. . . ]