User manual KORG EC5

[. . . ] Modulation with 5 MIDI syncable LFO shapes to create more complex and expressive sounds. New Multi-Mode Resonant Filter with four types: Low Pass, High Pass, Band Pass and Band Pass +. Three Stereo Effects processors with 16 different effects to select from and selectable effects routings. Expanded Motion Sequence function with up to 24 parts of Motion Sequence per pattern. [. . . ] FX SELECT, filter TYPE). Working with the ARPEGGIATOR 1. Select a part that you would like to arpeggiate by pressing its PART key. Press the RIBBON to play a part and change its note duration (length of the note) or note division (note type i. e. half, 4th, 8th 16th), depending on the PART that is selected. (DRUM, STRETCH and SLICE parts will have note division assigned to the RIBBON, Keyboard parts will have note duration assigned). If the part selected is a KEYBOARD part, then you can move the SLIDER up and down to select different notes. To assign a scale type to the SLIDER, select the ARPEGGIO SCALE page in the PATTERN mode using the PATTERN and keys, and then turn the VALUE dial to select the desired scale type. Remember that the scale type will be based on the root note(s) that you play on the 16 STEP KEYS/KEYBOARD. 3. Press the PART key of the part that you would like to record MOTION SEQUENCE on. Press the MOTION SEQUENCE key in the PART COMMON section so that the LED next to either SMOOTH or TRIG HOLD is illuminated. Press REC ( ) and then press PLAY ( ) to start playback and enable recording of MOTION SEQUENCE. To turn a step on or off, just press its key. If there are additional bars in a pattern you can see which STEP keys are played by using the keys and selecting the bar. The top green LED 1-8 shows which bar is playing, the bottom red LED 1-8 shows the bar you are currently viewing/editing. Repeat this process for each part you would like to record, you do not have to stop the pattern playback to record a new part. You can also use the ARPEGGIATOR when recording parts. To save or write your pattern into memory, press the WRITE key until it flashes. Then select the destination pattern number and press the WRITE key again. To name or rename your pattern, press and hold the SHIFT key the press the WRITE key and use the keys and Value dial to change the characters on the screen. 9. ESX-1 Easy Start Working in Song Mode 1. To enter the SONG mode press the SONG mode key. To create a new song select an empty song number or use the CLEAR SONG function by pressing and holding the SHIFT key and then press STEP key 10. [. . . ] keys to select “AutoSmpl” in the LCD screen and adjust the / ) key. To use AUTO SAMPLING (threshold sampling), use the level using the VALUE dial, then repeat step #7. To listen to your sample, play any of the DRUM PART keys or press the PLAY/PAUSE ( 10. To save/write your sample into memory, press the WRITE key, select the sample destination number and then press the WRITE key again. To name or rename the sample, press and hold the SHIFT key and then press the WRITE key, then use the keys and the VALUE dial to change the characters on the screen. Resampling a Pattern 1. [. . . ]