User manual KORG ES1

[. . . ] Thank you purchasing the Korg ELECTRIBE·S ES-1. In order to enjoy long and trouble-free use, please read this manual carefully and use the instrument correctly. E 3 To ensure long, trouble-free operation, please read this manual carefully. Precautions Location Using the unit in the following locations can result in a malfunction. • In direct sunlight • Locations of extreme temperature or humidity • Excessively dusty or dirty locations • Locations where excessive vibration exists Power supply Please connect the designated AC adaptor to an AC outlet of the correct voltage. [. . . ] In the case of a newly recorded sample, the display will blink “- -. ” (or “- -. S” for a stereo sample). Use the dial to select the writing destination sample number. In the case of a monaural sample (including slice samples), you can choose from “00. ” through “99. ” In the case of a stereo sample, you can choose from “00. S” through “49. S. ” When you choose the unused sample number, a period is indicated on the lower right Lit side of display. Press the Write key once again, and the display will indicate that the data is being saved. When saving is complete, the display will change to the save destination number and the Write key will go dark. If you decide to cancel without writing, press the Stop/Cancel key. 1 2 2, 3 2 1, 3 With the factory settings, Memory Protect is turned on so that data cannot be saved. You must turn off Memory Protect before you execute the Write operation. (p. 56 “Memory Protect (Protect)”) When you execute the Write operation, the sample that had occupied the save destination will be overwritten. The data locations within internal memory are optimized when you write a sample, and this may take a certain amount of time (maximum of approximately 90 seconds). During this time, the display will show that the data is currently being saved. The animation is indicated on the display during writing the sample. Never turn off the power until the data has been completely saved (i. e. , until the Write key goes dark). There is no need to write a sliced sample to a different location. The same location can play back the original sample (if assigned to part 1—7B) or the sliced sample (if assigned to slice part). 5. Pattern mode In this mode you can play patterns, or edit them to make new patterns. Press the PATTERN mode key to enter Pattern mode. Selecting a pattern Pattern A01. . . b64 Pattern A01 Pattern A21 Use the cursor keys to make the parameter select LEDs indicate Pattern. Rotate the dial to select one of the 128 patterns: A01. . . A64, b01. . . b64. Setting the playback tempo Tempo 20. 0. . . 300. 0 • Using the dial to change the tempo Use the cursor keys to make the parameter select LEDs indicate Tempo. If you wish to change the tempo units below the decimal place, hold down the Shift key and rotate the dial. In order to ensure that the rhythm always matches, you will need to perform this adjustment each time. • Using the Tap Tempo key to change the tempo While the pattern is playing, press the Tap key three times or more at the desired tempo. The ES-1 will calculate the interval at which you pressed the Tap key, and will change the tempo accordingly. You can change the tempo in the same way even when playback is stopped. When you use the cursor keys to make the parameter select LEDs indicate Tempo, and the tempo you modified will appear in the display. If you switch to a different pattern without writing the pattern whose tempo you modified, the pattern tempo will return to the previous value. [. . . ] -------------------- 37 Resonance --------------------- 37 Reso. ----------------------- 37 Reverb --------------------------- 36 Reverse --------------------- 9, 35 61 8. Appendices ○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○ Pattern Change timing --------------- 33 Play ----------------------- 14, 33 Rhythm ------------------- 18, 40 Set ------------------ 11, 25, 46 Write ---------------------- 20, 47 Pattern mode------------------- 33 Pattern Set---------------------- 11 Pattern Set Play ----------------------- 25, 46 Registering ------------------- 46 Write --------------------------- 46 Peak -------------------------------- 8 Peak LED ------------------------- 8 Phaser --------------------------- 36 Pitch Shifter -------------------- 37 Pitch/Speed ---------------- 9, 36 Play Beginning of a pattern ---- 33 Beginning of a song ------- 48 Motion Sequence ------ 21, 45 Pattern ------------------- 14, 33 Pattern Set -------------- 25, 46 Song ---------------------- 13, 48 Position --------------------- 48, 49 Protect --------------------------- 56 Rewind --------------------------Ring Mod. ----------------------Roll ---------------------- 9, 35, Roll Type -----------------------48 37 40 40 8. [. . . ]