User manual KORG GT120 2

[. . . ] Do not connect it to an AC outlet of voltage other than that for which your unit is intended. Sound mode 1. Make the settings described in steps 1­4 of "Meter mode. " 2. Press the [SOUND] switch to enter Sound mode (manual). [. . . ] Move the appropriate instrument name to the mark. Each setting allows the following tuning. ( ): Default values for MANUAL CHROMATIC : C, C , D, E , E, F, F , G, G , A, B , B (A, sound output: A4) GUITAR : 6E, 5A, 4D, 3G, 2B, 1E (6E) OPEN D : 6D, 5A, 4D, 3F , 2A, 1D (6D) OPEN E : 6E, 5B, 4E, 3G , 2B, 1E (6E) OPEN G : 6D, 5G, 4D, 3G, 2B, 1D (6D) OPEN A : 6E, 5A, 4E, 3A, 2C , 1E (6E) DADGAD : 6D, 5A, 4D, 3G, 2A, 1D (6D) BASS : LB, 4E, 3A, 2D, 1G, HC (LB) LB: Low B, HC: High C 5. When using AUTO Play a single note on your instrument, and the name of the nearest note will appear in the LCD display. Tune your instrument so that the correct note name is shown in the LCD display. When using MANUAL Press the [NOTE] switch until the note you wish to tune (C­B) appears in the LCD display. · Each time you press the [AUTO/MANUAL] switch, the setting will switch between AUTO and MANUAL. Handling To avoid breakage, do not apply excessive force to the switches or controls. Care If the exterior becomes dirty, wipe it with a clean, dry cloth. Do not use liquid cleaners such as benzene or thinner, or cleaning compounds or flammable polishes. Flat tuning When the [TUNING TYPE] dial is set to GUITAR or BASS, you can use Meter mode or Sound mode to tune to a pitch that is lowered by 1­4 ) for the specified note. As described in "Meter mode" or "Sound mode, " make the note you wish to flatten by 1­4 semitones appear in the LCD display. Set the [TUNING TYPE] dial to either GUITAR or BASS. Flat tuning can only be used for these selections. Press the [FLAT] switch to select the number of semitones that you wish to lower the selected note. The LCD screen will indicate ­ (1­4 semitones). Tune your instrument. Keep this manual After reading this manual, please keep it for later reference. Keeping foreign matter out of your equipment · Never set any container with liquid in it near this equipment. [. . . ] · Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. · Consult the dealer or an experienced radio/TV technician for help. Unauthorized changes or modification to this system can void the user's authority to operate this equipment. Using the stand By opening the stand located on the back, you can position the GT-120 at a convenient angle. [. . . ]