User manual KORG HA40

[. . . ] If liquid gets into the equipment, it could cause a breakdown, fire, or electrical shock. Be careful not to let metal objects get into the equipment. THE FCC REGULATION WARNING (for USA) This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. [. . . ] If you have purchased this product via the internet, through mail order, and/or via a telephone sale, you must verify that this product is intended to be used in the country in which you reside. WARNING: Use of this product in any country other than that for which it is intended could be dangerous and could invalidate the manufacturer’s or distributor’s warranty. Please also retain your receipt as proof of purchase otherwise your product may be disqualified from the manufacturer’s or distributor’s warranty. Precauciones Ubicación El uso de la unidad en las siguientes ubicaciones puede dar como resultado un mal funcionamiento: • Expuesto a la luz directa del sol • Zonas de extremada temperatura o humedad • Zonas con exceso de suciedad o polvo • Zonas con excesiva vibración • Cercano a campos magnéticos Introduction Installing the batteries Slide and remove the battery cover located on the rear of the HA-40. Insert the batteries observing the correct polarity. If the unit malfunctions and you are unable to correct the problem by turning the power off and on several times, remove the batteries and then reinstall them. The included batteries are provided so that you can verify that the unit operates correctly; their lifespan may be shorter than normal. If the batteries have run down, the battery symbol will appear in the left of the display. When this occurs, please install new batteries as soon as possible. Turn off the HA-40 before you replace the batteries. b11 tuning: C13 tuning: 6B , 5D , 4F , 3A , 2C , 1E 6A , 5C , 4E , 3G , 2A , 1C 4. The name of the note closest to the pitch you played will appear in the upper left of the display. Tune your instrument so that the desired note name appears. If you're using the internal mic, position your instrument as close as possible to the internal mic so that extraneous background noise is not picked up while tuning. While playing a single note on your instrument, tune your instrument so that the tip of the needle is in the center of the display and the center indicator of the tuning guide is lit (if you're tuning to a reference of A=440 Hz). The left indicator of the tuning guide will light if your instrument is flat, and the right indicator will light if your instrument is sharp. For example if you're tuning to a reference of 442 Hz, tune your instrument so that the tip of the tuning needle is one step to the right of the center. Using the stand You can use the HA-40 in an upright position by opening the stand located on the rear of the unit. Sound Out mode This mode lets you tune while listening to a reference tone. The HA-40 will be in Sound Out mode, and its speaker will sound a reference tone. Press the [SOUND] button to select the desired note name. The sound you hear will be one octave higher than the actual pitch of a steel guitar. [. . . ] When tuning an electric instrument Use an instrument a cable with mono plugs to connect your instrument to the HA-40's INPUT jack. If you connect a cable to the INPUT jack, you won't be able to use the internal mic. You can connect the HA-40's OUTPUT jack to your amp or other device. In this case, you should first connect your instrument to the HA-40's INPUT jack, and then use an instrument cable with mono plugs to connect the OUTPUT jack to your amp. [. . . ]