User manual KORG KAOSS PAD QUAD

[. . . ] 1 Precautions Location Using the unit in the following locations can result in a malfunction. €¢ In direct sunlight • Locations of extreme temperature or humidity • Excessively dusty or dirty locations • Locations of excessive vibration • Close to magnetic fields Power supply Please connect the designated AC adapter to an AC outlet of the correct voltage. Do not connect it to an AC outlet of voltage other than that for which your unit is intended. Interference with other electrical devices Radios and televisions placed nearby may experience reception interference. [. . . ] TIP The PHONES VOLUME knob does not affect the level at the LINE OUT jack. Press the Power button to turn the KAOSS PAD QUAD on. To turn the KAOSS PAD QUAD off, press and hold down the Power button until the display indicators turn off. The settings will not be retained after the power is turned off. Auto Power Off The KAOSS PAD QUAD features an Auto Power Off function, which turns the unit off automatically if the unit is left unused for approximately four hours. TIP If any sound is being input, this function will not kick in. selecting an effect The KAOSS PAD QUAD features four effect modules (1–4). You can assign a different effect to each of these four models. Touching the touch pad will cause all selected effects to be applied to the sound. You can also continue applying the effects by pressing the FREEZE button. 7)” TIP Effects are applied in ascending order of the effect modules (1 to 4). Disabling the Auto Power Off function Follow the steps below to disable the Auto Power Off function. Turn the KAOSS PAD QUAD on while pressing and holding down the 1DELAY button. The unit will indicate the current settings on the display. Rotate the BPM knob to select “dis” on the display. Press the TAP button to store this setting. To enable the Auto Power Off function, turn the KAOSS PAD QUAD on while pressing and holding down the 1DELAY button. Rotate the BPM knob to select “Ena” on the display, then press the TAP button. TIP If you turn the unit off without pressing the TAP 1. select an effect by pressing the corresponding Effect Type button. The selected Effect Type button indicator will light up. To turn the effect off, press the illuminated Effect Type button. [. . . ] The Auto BPM function will turn off, and the unit will use the BPM value obtained at the point you turned off the function. VINYL BREAK This effect simulates the sound heard when a turntable is stopped. Rubbing the touch pad will simulate the scratch technique. Delay/Rev category 1DELAY This effect delays the input sound and plays just one delay sound. [. . . ]