User manual KORG KEYBOARD ASSEMBLY 61KEY

[. . . ] Notice regarding disposal (for EU) If this "crossed-out wheeled bin" symbol is shown on the product or in the operating manual, you must dispose of the product in an appropriate way. Do not dispose of this product along with your household trash. By disposing of this product correctly, you can avoid environmental harm or health risk. The correct method of disposal will depend on your locality, so please contact the appropriate local authorities for details. [. . . ] Be careful not to pinch your hand while raising or lowering the module. Be sure that the module is powered-off when you connect or disconnect the cable between the keyboard assembly and the module. If you connect or disconnect this cable while the power is on, the module may stop operating correctly. Before you proceed, be sure to read and follow the "Safety precautions" found earlier in this manual. Parts and their functions Don't lose these screws!By touching or rubbing your finger on this ribbon you can control various program and effect parameters on the connected module. Don't tilt the module too far, since this will subject the keyboard assembly to excessive strain. By moving the joystick up/down/left/right you can control various program and effect parameters on the connected module. You can use these switches to control various program or effect parameters on the connected module, or to turn the joystick or ribbon controller's Lock function on/off. One end of the connecting cable (8) will plug into this jack, and the other end will plug into the module's TO KYBD port. When connected, you'll be able to use the keyboard assembly's keyboard, joystick, ribbon controller and switches to control the module. This is used to lock the module to the keyboard assembly. These supports lock the module to the keyboard assembly. They also support the module when it is used in the tilted position. Each locking support "B" that had been used to attach the module to the keyboard assembly in step 1. While supporting the module with one hand, fold in each of the locking supports "B" , and fold out the tab portion that had been inside. Be careful not to pinch your hand between locking supports "B" and the module. Slowly lower the module onto the locking supports "B, " Ensuring that the screw hole of each locking support "B" is aligned with the screw holes on the rear of the module. At this time, the protrusion of each locking support "B" will fit into a notch on the bottom of the module, helping to hold the module in place as you perform the next step. Be careful not to pinch your hand between locking supports "B" and the module. [. . . ] Before you transport the completed system (the keyboard assembly and attached module), you must be sure to tighten the two screws that fasten locking supports "B" to the module. * Appearance and specifications of this product are subject to change without notice. While using one hand to raise the module, connect the The included cable is only for the purpose of connecting the TO KYBD connector with the TO MODULE connector. Do not connect it to any other connector. [. . . ]