User manual KORG KEYBOARD ASSEMBLY 88KEY

[. . . ] Notice regarding disposal (for EU) If this "crossed-out wheeled bin" symbol is shown on the product or in the operating manual, you must dispose of the product in an appropriate way. Do not dispose of this product along with your household trash. By disposing of this product correctly, you can avoid environmental harm or health risk. The correct method of disposal will depend on your locality, so please contact the appropriate local authorities for details. [. . . ] Be sure that the module is powered-off when you connect or disconnect the cable between the keyboard assembly and the module. If you connect or disconnect this cable while the power is on, the module may stop operating correctly. Before you proceed, be sure to read and follow the "Safety precautions" found earlier in this manual. Loosen the screw A that holds the lock plate, turn the lock Plate 180 degrees as shown, and fit it into the slot in the bracket. Tighten the lock plate screw A to secure it in place. If you move the keyboard assembly or apply excessive force to the module without fastening the lock plate to the bracket, the module may fall down resulting in damage or injury. For safety, fit the lock plate into the bracket and fasten it with the screw A. Also tighten the screw on the module so that it does not fall out. Loosen the screw A securing the lock plate. Using the handle located on the rear panel, lift the module until it stops; and release the handle. Rotate the lock plate 180 degrees, fit it into the slot of the Support arm, and tighten the screw to fasten it. A securing the lock plate to the arm, then gently lift the module using the handle located on the rear panel and release it. Be careful not to pinch your hand between the module and the keyboard assembly. If the module is lying flat in the storage position, raise it Loosen the screw on the module and the screw A that As shown in the illustration, use your Phillips (+) screwdriver to remove the two screws B that attach the support arm to the module. Be careful not to lose the screws you remove. Be careful not to lose the screws you remove. Align the screw holes in the retaining bar with the screw holes in the keyboard assembly, and finger-tighten the four screws. Finally, use your Phillips (+) screwdriver to firmly tighten the four screws. Don't attempt to forcibly tighten the screws if the screw holes are not aligned. Remove the retaining bar, and then lift the module using Both hands and remove it from the keyboard assembly. Be careful not to pinch your hand between the module and keyboard assembly. Using the handle located on the rear panel, lift the module up, align the screw holes in the module with the screw holes in the support arm, and use your Phillips (+) screwdriver to install the two screws B that you removed when detaching the module. [. . . ] In order to execute this command, the M3-M must be connected to the TO MODULE connector. If you transport the keyboard assembly with the module in the raised position, the lock plate must be fitted into the slot on the bracket and secured in place by tightening the lockplate screw. If you transport the keyboard assembly with the module in the lowered (storage) position, the latch must be connected to the module, with both the module and bracket screws securely fastened. If you transport the system without fastening these screws, the module may move abruptly, causing damage or injury. [. . . ]