User manual KORG MS-03 SERVICE MANUAL

[. . . ] Do not defeat the safety purpose of the polarized or groundingtype plug. A polarized plug has two blades with one wider than the other. A grounding type plug has two blades and a third grounding prong. The wide blade or the third prong are provided for your safety. [. . . ] When bouncing to one track, you can choose any track. However when bouncing to two tracks, you can only select a pair of adjacent tracks (1-2, 3-4, 5-6, or 7-8). 2-1. Recording channel tracks Here's how to record channel tracks. You can record up to eight channels simultaneously. 2) Connect an audio source to the channel on which you want to record it (p. 24 "1-1. 3) Put the channel to be recorded in Record mode. · Turn the REC/PLAY button on, and set the appropriate channel button to Record mode (lit red). Adjust the TRIM knob so that the PEAK LED does not light when the audio input source is at its maximum volume. When making this adjustment, you can switch the display to the Level Meter screen and press the EXIT/CANCEL button to select the input display (IN) so that you can view the levels. 5) Adjust the monitor level (p. 24 "1-3. 6) Move the current location to the point at which you want to start recording. 6) Move the current location to the point at which you want to start recording. You can move to the beginning of the song by holding down the STOP button and pressing the REW button. 7) Put the recorder in record-ready mode. (The REC and PLAY buttons will light. ) Playback will begin. When playback ends, press the STOP button. (The REC and PLAY buttons will go dark. ) Return to the location at which you began recording, and play back to verify that recording occurred correctly. 1) Make sure that you've selected the desired virtual track for each playback track 1­8 you want to record to the master track. Press the CH ON button, and press the channel button for each track you don't want to play, making the channel button go dark. 3) Press the MASTER button several times to make it light red. The channel buttons of the playback tracks will be green. 4) Perform steps 4) and following of "2-3. You can also use the effect while you record the master track (p. 33). Combining multiple tracks into one track (monaural) 1) Make sure that you've selected the desired virtual track for each playback track you want to bounce. If there are any tracks you don't want to include, lower their faders or press the CH ON button and then press the corresponding channel buttons to mute (silence) those tracks. 2) Press the BOUNCE button, and then press a channel button to specify the bounce-destination. [. . . ] The MS-03 can only recognize data that is in this folder. MS-03PM. SYS This file contains settings used by the system. There must always be one and only one of this file. SONG0001 folder (song folders) There will be one of these folders for each song you create. [. . . ]