User manual KORG OT120 3

[. . . ] · In direct sunlight · Locations of extreme temperature or humidity · Excessively dusty or dirty locations · Locations of excessive vibration · Close to magnetic fields LCD display Meter Reference pitch volume (two steps) Key, Temperament name Note name, Octave Tuning guide Internal mic NOTE[]/[®] switches CALIB[]/[®] switches [MODE] dial OUTPUT jack (output) This setting will be remembered even if you change modes. Play a single note on your instrument, and tune so that the VU style meter moves to the 0 position (center) and the tuning guide indicators are both lit. The meter will operate when the difference between the specified note and the input pitch is in the range of -500 cents ­ +500 cents. Adjustment screw 2. [. . . ] Since this may cause noise during your performance, set the power switch of the OT­120 to STANDBY . If you are using the internal mic of the OT­120, tune without connecting a plug to the INPUT jack and OUTPUT jack. If a plug is connected to the INPUT jack or OUTPUT jack, the internal mic cannot be used. The INPUT and OUTPUT jacks are for mono use only. Stereo plugs cannot be used. Keep this manual After reading this manual, please keep it for later reference. Keeping foreign matter out of your equipment Never set any container with liquid in it near this equipment. If liquid gets into the equipment, it could cause a breakdown, fire, or electrical shock. Be careful not to let metal objects get into the equipment. If something does slip into the equipment, unplug the AC adapter from the wall outlet. Then contact your nearest Korg dealer or the store where the equipment was purchased. Specifications Scale Transposition range Detection range Reference tone Tuning modes Calibration range Detection accuracy Sound accuracy Tuning guide range : 12 equal tempered, Pythagorean, Mean tone E /D , Werckmeister III, Kirnberger III, Kellner, Vallotti, Young : C, C , D, E , E, F, F , G, G , A, B , B : A0 (27. 50 Hz)­C8 (4186 Hz) : C2 (65. 41 Hz)­C7 (2093 Hz) five octaves, two volume levels : Manual, Auto (SLOW, MEDIUM, FAST), Sound, Sound Back : A4=349­499 Hz (1 Hz steps) : +/-1 cent : +/-1. 5 cents : for AUTO (SLOW, MEDIUM, FAST), SOUND BACK modes -50 cents ­ -3 cents : -3 cents ­ +3 cents :, +3 cents ­ +50 cents : for MANUAL mode -500 cents ­ -3 cents : -3 cents ­ +3 cents :, +3 cents ­ +500 cents : : INPUT (1/4" mono), OUTPUT (1/4" mono), DC IN (9V ) : AAA batteries x 2 (3 V), or AC adapter : approximately 100 hours (alkaline batteries, Meter mode, continuous input at A4) : 74 x 120 x 36 mm [2. 91" x 4. 71" x 1. 42" ] : 193g [6. 8 oz] (with batteries) : Alkaline AAA (LR03) batteries x 2 to verify operation : AC adapter (9V ) THE FCC REGULATION WARNING (for U. S. A. ) This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: · Reorient or relocate the receiving antenna. · Increase the separation between the equipment and receiver. · Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. · Consult the dealer or an experienced radio/TV technician for help. [. . . ] The setting produces a low-volume reference tone. The setting produces a loud reference tone. * Appearance and specifications are subject to change without notice. IMPORTANT NOTICE TO CONSUMERS This product has been manufactured according to strict specifications and voltage requirements that are applicable in the country in which it is intended that this product should be used. If you have purchased this product via the internet, through mail order, and/or via a telephone sale, you must verify that this product is intended to be used in the country in which you reside. [. . . ]