User manual KORG PA1XPRO EASY START GUIDE

[. . . ] Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two blades with one wider than the other. A grounding type plug has two blades and a third grounding prong. [. . . ] At least one track must already be recorded. Warning: The Auto Punch function overwrites existing notes. 2. Use the SCROLL / buttons to move the cursor to the S (Start Measure) or E (End Measure) parameters, and use the +/YES and -/NO buttons to choose the start and end recording measures. 1. Be sure to choose the Pnc (Auto Punch) recording mode (see “Step 3: Setting the record options” on page 29): 3. Press the EXIT button to return to the Record page. Make the PART 1 and/or PART 2 indicator flash, depending on the part(s) you want to record. 5. Recording will automatically begin at the “Start” position, and stop at the “End” position. Record Mode 1 Pnc S:001 E:001 Start Measure End Measure 6. When finished, press STOP to end recording. 32 PA1XPRO_English. fm Page 33 Tuesday, October 10, 2006 4:14 PM Recording a song > Saving the song Saving the song After recording, the song is stored into a temporary, non-permanent memory. To preserve it from deletion when turning the instrument off or choosing a different song, you must save it into the User Song album. Press the +/YES button to save the song into the User Song album, or the -/NO button to return to the Song Play mode, without saving the song. As an alternative, you can press EXIT to exit without saving, or to continue recording the current song. By choosing the Save Song command You can select the Save Song command at any moment. Please note that songs contained in albums other than UserSong cannot be edited. The only Edit function that can be accessed with these songs is the Cycle Play. Setting Cycle Play Cycle Play allows you to repeat a passage during play, to practice with it over and over. Note: If you enter editing later, you might see a different edit page instead of the first one. Use the SCROLL button to reach it. Play mode, whose use has been seen above (see “Cycle Play” on page 26): Cycle Play 1 On S:001 E:001 Start Measure End Measure 1. While in Song Play mode, press the EDIT button. The first page of the Song Edit mode will appear. Press the EXIT button to return to the Main page and start practicing. Erasing a track You can erase a single or all song tracks, to start recording them again, or just remove them from the song (for example, the voice track you want to sing live). 3. Press the SCROLL Exec command. button to move the cursor to the 4. The “Are you sure?” message appears. Press +/YES to confirm, -/NO to cancel and keep the track. 1. After having pressed the EDIT button, use the SCROLL button to go to the Erase Track edit page: Erase Track 2 All Exec? 5. Press the EXIT button to return to the Main page and save the changes (see “Saving the song after editing” on page 36), or the SCROLL button to go to the next edit page (see below). 2. [. . . ] If it is, bring it up to an adequate level. (2) Make sure there is not a jack plugged into one of the PHONES connectors. This would turn the internal speakers off. (3) Make sure that the MIDI Local function is not set on OFF. [. . . ]