User manual KORG PA588

[. . . ] 1. 0 User’s Manual Pa588-100UM-ENG. book Page ii Monday, May 26, 2008 4:34 PM Important safety instructions Location Using the unit in the following locations can result in a malfunction. • • • • • In direct sunlight Locations of extreme temperature or humidity Excessively dusty or dirty locations Locations of excessive vibration Close to magnetic fields THE FCC REGULATION WARNING (for U. S. A. ) This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. [. . . ] Note: Some of the events are “ghosted”, and non editable, since the corresponding events are not editable in a Pad. This is very similar to the Style Record’s Event Edit Filter page. See “Event Edit: Filter” on page 119 for more information on the filter page. After setting the various parameters, press Execute. CV (Chord Variation) Use this parameter to select the Chord Variation for editing. Value Pad Edit: Quantize The quantize function may be used to correct any timing mistake after recording, or to give the pattern a “groovy” feeling. Transpose value (±127 semitones). Start / End Tick Use these parameters to set the starting and ending points of the range to be transposed. Bottom / Top Note Use these parameters to set the bottom and top of the keyboard range to be transposed. Execute Press this button to execute the operation set in this page. After setting the various parameters, press Execute. CV (Chord Variation) Use this parameter to select the Chord Variation for editing. Resolution This parameter sets the quantization after recording. Start / End Tick Use these parameters to set the starting and ending points of the range to quantize. Bottom / Top Note Use these parameters to set the bottom and top of the keyboard range to quantize. Execute Press this button to execute the operation set in this page. Reference Pa588-100UM-ENG. book Page 140 Monday, May 26, 2008 4:34 PM 140 Pad Record mode Pad Edit: Velocity Pad Edit: Velocity In this page you can change the velocity (dynamics) value of notes in the selected track. Pad Edit: Cut This function lets you quickly delete a selected measure (or a series of measures) from the selected Chord Variation. All following events are moved back, to replace the cut measure(s). After setting the various parameters, press Execute. After setting the various parameters, press Execute. CV (Chord Variation) Use this parameter to select the Chord Variation for editing. Value Start CV (Chord Variation) Use this parameter to select the Chord Variation for editing. Velocity change value (±127). Intensity (Only available in Advanced mode). Use this parameter to specify the degree to which the velocity data will be adjusted toward the curve you specify in “Curve”. Curve (Only available in Advanced mode). Use this parameter to select from six types of curve, and specify how the velocity will change over time. Value (Only available in Advanced mode). Velocity change at the starting and ending ticks of the selected range. [. . . ] Has one of the USER Drum Kits been modified?Have the Styles or Performances been modified?Load the appropriate data (Styles or Performances). Sound does not stop The selected Style or Song cannot start Make sure that the damper pedal polarity parameter is set correctly. [. . . ]