User manual KORG PANDORA PX5D

[. . . ] Using the unit in the following locations can result in a malfunction. If the exterior becomes dirty, wipe it with a clean, dry cloth. After reading this manual, please keep it for later reference. Keeping foreign matter out of your equipment Never set any container with liquid in it near this equipment. [. . . ] Use the volume control of your connected device to adjust the volume balance. If Song Play was last selected in Rhythm & Bass mode, you won't be able to select "JAM" as the recording mode. Use the value dial to select the recording time (for "JAM, " the number of measures). In Play mode (except during bypass/mute or key lock), Rhythm & Bass mode, or Utility mode, press the PHRASE TRAINER button to enter Phrase Trainer mode. When you enter this mode, the recording mode and time select screen will appear, and the Phrase Trainer icon will blink. In this screen, the PX5D will be ready to record. If the recording mode is "JAM" and the tempo of the rhythm is extremely slow, it will not be possible to record a large number of measures. Please adjust the tempo in Rhythm & Bass mode (maximum length is approximately 80 seconds) If you want to use Chain in Rhythm & Bass mode to record a one-measure rhythm pattern etc. In "JAM" mode using multiple patterns, specify the number of recording measures to be the number of patterns you're using. For example if you want to use two patterns of a 2/4 time signature to record a one-measure pattern of a 4/4 time signature, specify 2 measures as the number of recording measures. Start playback on your CD or other audio source, and at the point where you wish to begin recording, press the ENTER/REC button. You can use a foot switch connected to the FOOTSW jack to start/stop recording (p. If, after recording, you want to change the recording mode or recording time, press the PHRASE TRAINER button while playback is paused. If you do not stop recording, recording will continue until the selected recording time or number of measures has elapsed, and loop playback will begin automatically. During playback or while paused, you can use the / CURSOR to select programs. Start the CD or other audio source, and press the ENTER/ REC button at the beginning of the desired phrase. If you want to change the recording mode or time, press the PHRASE TRAINER button while paused. If you want to save the phrase you recorded, press the PHRASE TRAINER button several times while paused until the LCD indicates "SAVE?Then press the ENTER/ REC button once again to save the phrase. Rotating the Value encoder toward the left will slow down the playback speed without affecting the pitch. You can choose from six levels of playback speed: 100%, 90%, 80%, 75%, 66%, and 50%. During playback, you can hold down the CURSOR to rewind, or hold down the ® CURSOR to fast-forward. [. . . ] Make connections to the headphone jack of the device, instead of to its line output. Are you using a connection cable with a built-in resistor?Are the effects used in the program turned on?Could the lens of your CD drive be dirty? [. . . ]