User manual KORG README

[. . . ] Unzip all the files in the zip file before proceeding to step 3. The updater may not be able to find necessary files if they were not unzipped. Hold down the [SETTING], [MESSAGE], [EXIT], and [OCTAVE SHIFT / CURSOR >] keys, and then turn on the power of the microKONTROL / KONTROL49. (Note: Nothing will appear on the microKONTROL / KONTROL49 display - don't worry!) The microKONTROL / KONTROL49 will be recognized as a new device, and the following "Found New Hardware Wizard" window will appear. [. . . ] The following window will appear during the update process. Caution: Do not turn off the microKONTROL / KONTROL49 during the update process. Note that the whole process will take several minutes to complete. 4 10. After the update is finished, the following window will appear. Press the [OK] button to uninstall the driver. 12. After the uninstall process, the following window will appear. This will conclude the entire update procedure. Quit the KONTROL Updater, and reboot the microKONTROL / KONTROL49. 5 Update Procedures (for Mac users) 1. Connect the microKONTROL / KONTROL49 to your computer using a USB cable. Mount the "KONTROL_Updater_March_2006. dmg" by double-clicking on it, and run the "KONTROL Updater March-2006" in the disk image by double-clicking on it. Hold down the [SETTING], [MESSAGE], [EXIT], and [OCTAVE SHIFT / CURSOR >] buttons, and then turn on the power of the microKONTROL / KONTROL49. (Note: Nothing will appear on the microKONTROL / KONTROL49 display - don't worry!) The message in the window will change as follows (the following procedures and windows are for updating the KONTROL49, but are very similar when updating the microKONTROL). If you use a USB bus-powered hub, or your computer can't supply enough power to the microKONTROL / KONTROL49, the message in the window won't change. In this case, please use the supplied AC adapter. If the following message is shown, the system firmware is already up to date, and no update is necessary. If so, you can quit the KONTROL Updater. Caution: Do not turn off the microKONTROL / KONTROL49 during the update process. Note that the whole process will take several minutes to complete. The following message will be shown when the update has successfully completed: Quit the KONTROL Updater, and reboot the microKONTROL / KONTROL49. 7 Contents of the microKONTROL System Firmware Version 1. 03 Play Mode Ability to Send Program Change Messages: By default, Program Change messages [Cn mm] (n: Global MIDI Channel, mm: Program Number) will be sent by turning the Main Encoder. Adjusting the MIDI Clock Tempo: Turn the Main Encoder with the [SETTING] key held down. To adjust the tempo using only the Main Encoder, press the [MESSAGE] key while holding down the [SHIFT] key to latch the [MESSAGE] key. [. . . ] Others * Improved accuracy in recognizing whether the damper pedal is pressed down or not. 9 Contents of the KONTROL49 System Firmware Version 1. 06 KORG Native Mode Expanded Control Messages Control messages within KORG Native Mode have been expanded to enhance communication with compatible software such as Logic 7 from Apple Computer, Reason 3 from Propellerhead, etc. Note that some software may not support the expanded control messages. Please refer to the owner's manual of your software. Others * Improved accuracy in recognizing whether the KONTROL49 is connected to a computer or not. [. . . ]