User manual KORG SQ-10 SERVICE MANUAL

[. . . ] SQ-10 TouchView objects that you'll work with are: Tabs, Buttons, Boxes and Icons. How to Select and Listen to the Demo Songs: 1. Press the SONG key, then press the SelSong tab in the display. Press the > button to the left of the current song name. Press the button in the display, and press to highlight any demo song name. [. . . ] Press to highlight Copy, then press the OK button. button in the display - don't worry, the SQ-10 "knows" where the next-available empty song location is, as indicated in the display. Press the Yes button in the dialog box, then press the OK button to confirm the copy procedure. "NowSongLoading" will appear briefly. Press the SelSong tab, and you'll see the results of your efforts - Song I001: Alone has been copied to the new song location. Just like the original, the new copy is still protected. That's the next step. . . Un-protect the copied song: 1. Press the EditSong tab in the display, then press the Popup button to the left of CopySong. Press to highlight Protect, then press the OK button. button in the display - to the right of the "padlock" icon (protect). Now you can work freely with the copied song. Change the Counter Time Display Type: The original factory demos all display the time in real time - now you'll set the copied song so the Counter reads in measures, beats and ticks: 1. The audio data will play from that point at normal speed, for two seconds, then stop. Hold the STOP key and press the PLAY key. The audio data will play at normal speed, from two seconds before the OUT point and then stop. Press the OK button in the display, and note the registered IN and OUT time in the display. Press the Loop:Off button in the display, and the LOOP key will light. Now the registered time will loop repeatedly. After you've listened to the loop, press the STOP key, then press the Loop:On button in the display to exit Loop Playback mode. Tip: By using the WAVE and SCRUB functions, you can be more precise in locating IN and OUT points to set for Loop Playback (and Loop Recording). You can register IN and OUT Points while the SQ-10 is stopped or during playback, first by using the STORE and IN / OUT keys, and then by "fine-tuning" the loop points with the WAVE and SCRUB functions. Set IN and OUT points while the song plays back: 1. Press the SONG key, then locate to measure 001. 01. 000, by holding the STOP key and pressing the REW key once). Press the PLAY key, and listen to the song to get a feel for the rhythm. While the song plays, press the STORE key, followed by pressing the IN / LOC1 key, to store an IN point wherever you like. [. . . ] Be aware that this procedure writes over all data on the destination drive! SONG> EditSong> CopyAll> OK> Drive > select destination drive > OK> Exec> Yes 60 KORG SQ-10 Guide Track Editing Copy Track: Copies recorded track data from one region to another. You can copy single or multiple tracks with this function, and input how many times you want the selected region to be copied. You could use this function when you want to copy a recorded drum or bass groove repeatedly ­ to create track data for the entire song. You can also copy to the "clipboard", allowing you to copy track data from one song to another. [. . . ]