User manual KORG TRITONLEEASYSTART

[. . . ] For sales presentations, make sure to reload the demos each morning using the above procedure! Listening to the Demo Songs 1. After the preload demo songs have been loaded, press the [SEQ] key. CURSOR to highlight the "song name edit cell". Select a song ("Midnight Sun" or "DEEP ENDZ") with the DIAL or the [INC]/[DEC] keys. [. . . ] Press the [START/STOP] key to audition the copied drum pattern Press the [START/STOP] key again to stop. When you press [F6] to copy the pattern, you can first select a new pattern to create a series of patterns in the track. Press the [LOCATE] key to return to the beginning of the Song CURSOR to the Track edit cell on the main sequence page, and press the [INC] key to select Track 2 (except for the Orchestral Template, Track 2 is always Bass) Press the [REC/WRITE] key, and then the [START/STOP] key, and record 2 to 4 measures When finished, press [START/STOP] to stop recording. ! 3 TRITON Le EasyStart 5. Press the [MENU] key, and then press [F1] to highlight "Loop" Press [F8] to open the Loop Page Hold down the [TIMBRE/TRACK] key and press [F2] (or CURSOR ) to select Track 2 Press the [INC] key to "check" Track 2's "loop box" CURSOR and leave the "loop start value" at "measure 001" CURSOR and set the "loop end value" to the last measure you played on Track 2 Press [LOCATE] to move to the song beginning, and then press the [START/STOP] key to playback the song and looped bass track Press the [START/STOP] key again to stop. Repeat previous steps 4 and 5 as you record additional tracks and set desired Play Loops. 6. . . . Continue by Automating the Mix: 7. CURSOR to the "Track edit cell" and select a track from the previous steps for mixing. Press [F6] ("Pref"), and then press the [INC] key to select "Over Dub" for "REC setup. " Press [F4] to view the Mix for tracks 1-8. While holding down the [TIMBRE/TRACK] key, press the [F1] - [F8] keys to highlight one of the tracks. CURSOR once to highlight the volume parameter for the selected track. Press the [REC/WRITE] key, then the [START/STOP] key, and record volume changes on the track by using the DIAL Press [START/STOP] when finished. Press [START/STOP] to audition the results - the volume parameter and value will update as the song plays back. Note that track pan messages may be recorded in similar fashion. Using the Compare function as `UNDO' in Sequence mode If you are dissatisfied with a `take' or a recorded mix, press the [COMPARE] key once so it is lit: it serves as "one level of Undo". Simply Record again while the [COMPARE] key is lit, and you'll record new data in the current track. "Toggle" the COMPARE key to listen to both "takes". Note that moving to, and recording/editing another track (or leaving sequence mode) will clear the Compare buffer. Before you begin work on a new track, make sure that the currently selected state of Compare contains the data that you want to keep! Sampling with the EXB-SMPL Option The user-installable EXB-SMPL sampling option provides the user with everything needed for serious sampling: a pair of audio inputs with Level control and Mic/Line level switching, a SCSI connector, and 16 MB of Sampling RAM. The Triton LE samples at 48kHz, 16-bit, in mono or stereo. With the provided 16 MB, the Triton LE is capable of recording samples of 174 seconds @ mono, or 87 seconds @ stereo. Fully expanded with SIMM modules to 64 MB, it allows about 11 ½ mono minutes or 5. 8 stereo minutes of sampling!The correct SIMMS are 72-pin, non-parity, EDO or Fast Page (FPM) DRAM SIMM, 60 ns (nanoseconds) or faster, 11 Bit Addressing. Recording "one-shot" vocal samples 1. Connect a microphone to the [AUDIO INPUT 1] jack on the rear panel, set the MIC/LINE switch to MIC, and set the LEVEL control to the 12 o'clock position. Press the [SAMPLING] key Press [F1] ("Sample" tab) and make sure that "MS" (Multisample) is set to "000:new MS____000" CURSOR to, and set both the "Orig K" and "Top K" (original and top key) fields to a value of "C2". [. . . ] Now play the keyboard: play each note (half-step) from C2 to D#2, and you'll hear the sampled words, "Sampling is easy with TRITON Le". . . . Continue by sampling through one of TRITON Le's 89 Insert Effects: 13. Press [F3] ("In/Pref") CURSOR to Input 1's "BUS:" and select "IFX" select "IFX" Press [F8] to "Open" this page. Press the [MENU] key, and then press [F7] to CURSOR to "OFF" and set to "ON" CURSOR to highlight the "00 No Effect" edit cell Use the numeric keypad, to enter 5 > 2, then press the [ENTER] key ("52: Reverb Hall") Speak into the microphone to hear the effect being applied Press [F4] ("IFX ") to view and edit the effect parameters. Press the [MENU] key Press [F1] ("Rec") Press [F8] to "Open" this page Press [F1] ("Sample"). [. . . ]