User manual KORG ZERO4

[. . . ] Mains powered apparatus shall not be exposed to dripping or splashing and that no objects filled with liquids, such as vases, shall be placed on the apparatus. install in accordance with the manufacturer's instructions. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. Do not defeat the safety purpose of the polarized or grounding-type plug. [. . . ] The BPM cannot be detected correctly for songs that don't have a definite beat. The loop sampler and the master effect are connected to the SAMPLER/FX bus in series. The MASTER FX & SAMPLE MIX fader will adjust the mix balance between the sound that has passed through the loop sampler and master effect, and the sound ("dry" sound) selected by the CH SELECT switch. By pressing the CUE button, you can monitor the "wet" sound via the CUE bus even if this is set to the "dry" side. This is a loop sampler that lets you play the recorded sample using either Gate Play or Loop Play methods. When you operate the TIME knob, the specified TIME parameter is shown in the display for approximately two seconds. For example, a beat of 1/4 (quarter note) is shown as "1. Use the LOOP LENGTH knob to specify the number of beats that will be recorded/played-back. For example if you set the LOOP LENGTH knob to "1/4", the length will be one quarter-note beat. To sample with Gate Play When you press the GATE PLAY button, sampling will occur only for the time specified by the LOOP LENGTH knob. Loop playback will continue while you continue holding down the GATE PLAY button. To sample with Loop Play When you press the LOOP PLAY button, recording will occur only for the time specified by the LOOP LENGTH knob, and then loop playback will continue even after you release the LOOP PLAY button. When you press the LOOP PLAY button once again, loop playback will stop. The master effect is applied only to the loop playback. When you press the lit KEEP button, the sample data stored in internal memory will be erased, and the KEEP button will go dark. Note: It's not possible to permanently save the recorded sample. Regardless of whether the sample was temporarily preserved or stored in internal memory, it will be lost when you turn off the power. If you continue sampling, this data will be overwritten. If you store the sampled data, you'll be able to play back this sample repeatedly. If you press the blinking KEEP button, the temporarily preserved sample data will be stored into internal memory. when the sample data has been stored , the KEEP button will light. If you press the GATE PLAY button or LOOP PLAY button while the KEEP button is blinking, new sampling will begin, and the temporarily preserved sample will be erased. [. . . ] It may be impossible to perform the installation successfully if other programs are running. Exit all other programs before you begin the installation. Have you correctly specified the input/output devices you want to use?Depending on the application you're using, you may need to make audio/MIDI device settings. [. . . ]