User manual KORG ZERO8

[. . . ] Mains powered apparatus shall not be exposed to dripping or splashing and that no objects filled with liquids, such as vases, shall be placed on the apparatus. install in accordance with the manufacturer's instructions. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. Do not defeat the safety purpose of the polarized or grounding-type plug. [. . . ] You can control up to six effect parameters assigned to the push-knobs by turning the corresponding knob. You can connect the ZERO8 to your computer via a FireWire cable and use it as an audio/MIDI interface. Note: Do not simultaneously connect more than one computer to the ZERO8. Note: If you are using a host application such as sequencing software, you'll need to make audio and MIDI device settings. for details , refer to the owner's manual of the software you're using. Note: You must connect the ZERO8 to your computer using a FireWire cable and turn on the power before you start up your software. Don't disconnect the FireWire cable or power-off the ZERO8 while the software is running. Note: If you're using the ZERO8 with Mac OS X, turn off the Sleep setting and power management settings. Note: Each input/output device can be used with only one software application. multi-client operation is not supported. Note: Use the included CD-ROM to install the "KORG FireWire Audio/MIDI driver" into the computer you're using. You can use the ZERO8 as an audio interface. This lets you send the ZERO8's audio inputs or mixed sound to your computer, and send the audio outputs from a host application on your computer to the ZERO8. Nor will you be able to use the EXT1 or EXT2 RETURN jacks. Note: When using the ZERO8 with Mac OS X Depending on the system you're using, you may experience problems such as the operating system becoming unstable when you switch the sampling frequency. If this occurs, you can start up as described below so that the ZERO8 will operate with a fixed sampling frequency. In this case, you won't be able to switch to another sampling frequency from the computer. 1 kHz: Turn on the power while holding down the mixer channel 1 Cue button. 48 kHz: Turn on the power while holding down the mixer channel 2 Cue button. 96 kHz: Turn on the power while holding down the mixer channel 3 Cue button. In the Mac OS System Settings / Sound / Output dialog box, verify that the ZERO8 has disappeared from the list of sound output devices, and then turn the power on once again. Depending on the type of computer you're using, starting up the computer with the ZERO8 already connected may cause operation to become unstable. [. . . ] Are you using a FireWire device other than the ZERO8?If the ZERO8 is connected to an external FireWire hard disk, you should re-connect the ZERO8 directly to the FireWire connector (IEEE 1394 connector, iLink connector, DV connector) of your computer. Turn off the power of all FireWire devices other than the ZERO8. In order to play back audio/MIDI using the ZERO8, you must install the KORG FireWire Audio/MIDI driver. [. . . ]