User manual KRESS 500 ST E

[. . . ] The symbols used in these instructions and, if applicable, on the power tool serve to bring your attention to potential dangers when working with this power tool. You must understand the significance of these symbols/notes and comply with them in order to make its use more efficient and safer. The safety warnings, notes and symbols are not a substitute for regulation measures for accident prevention. -WARNINGFor a potentially dangerous situation which could lead to physical injury or material damage. [. . . ] The saw blade can be damaged, break or cause kickback. 18 English certain residual risks that cannot be completely prevented through safety mechanisms. Therefore, electrical tools must always be operated with the EN necessary caution. Read all the warnings and instructions before using the equipment. Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury. While reading the operating instructions, unfold the graphics page for the machine and leave it open. The machine is intended for making separating cuts and cut-outs in wood, plastic, metal, ceramic plates and rubber while resting firmly on the workpiece. It is suitable for straight and curved cuts with mitre angles to 45°. The saw blade recommendations are to be observed. The personnel must be made aware of the relevant dangers. Jig saw V~ Nominal voltage Watt Input power Watt Output power min-1 min-1 500. Noise levels EN Measured values determined according to EN 60 745. Typically the A-weighted noise levels of the machine are: sound pressure level (LpA) 78 dB (A) 89 dB (A) sound power level (LwA) Measurement uncertainty K=3 dB The noise level can exceed 85 dB(A) during operation. Vibration Triaxial vibration emission level determined in accordance with EN 60745. Jig Saw 420 ST E 500 ST E Cutting wood; ah: m/s² 13, 1 11, 9 Measurement uncertainty K m/s² 2, 5 2, 5 Cutting sheet metal; ah: m/s² 19, 3 9, 4 Measurement uncertainty K m/s² 2, 8 2, 2 The vibration emission level given in this information sheet has been measured in accordance with a standardised test given in EN 60745 and may be used to compare one tool with another. The vibration emission level will vary because of the ways in which a power tool can be used and may increase above the level given in this information sheet. This could lead to underestimation of vibration when the tool is used regularly in such a manner. Note: To be accurate, an estimation of the level of exposure to vibration experienced during a given period of work should also take into account the times when the tool is switched off and when it is running but not actually when doing the job. This may significantly reduce the exposure level over the total working period. Idling speed stroke number n0 Kg 1, 8 2, 3 Weight Your power tool is double-insulated in accordance with EN 60745; For this reason an earth wire is not required. The device is suppressed against radio and TV broadcasts, in accordance with EN 55014-1 and is immune to disturbances in accordance with EN 55014-2. Operation Use only an original Kress mains cable module and at least a heavy rubber tube cable (H07RNF). [. . . ] In observance of the European Directive 2002/96/ EC for waste electrical and electronic equipment and its implementation in accordance with national law, electric tools that have reached the end of their life must be collected separately and returned to an environmentally compatible recycling facility. Before carrying out any work on the machine, pull the mains plug. always keep the machine and ventilation slots clean. Wipe off the accessible plastic parts regularly with a cloth without cleaning agent. [. . . ]