User manual KRESS 620 PEC

[. . . ] Therefore, always take a secure stance and hold the machine firmly with both hands. Pneumatic Drill Hammer Article number Input power Output power Electronic speed control No-load speed Speed under load No-load impact rate Impact energy Right/Left rotation Clamping collar dia. Wood Sheet metal Weight Protection class 1 Tool holder 2 Dust protection cap 3 Unlocking collar 4 Rotation stop switch 5 Ventilation slots 6 Rotational direction switch 7 Locking button for on/off switch 8 On/Off switch/Speed control 9 Drilling/Impact drilling selector 10 Holder for depth stop 11 Auxiliary handle 12 Latch for mains cable module 13 Adapter for screwdriver bits/drill chuck Accessories illustrated or described are not always included as standard delivery items. Typically the A-weighted noise levels of the machine are: sound pressure level 88 dB (A); sound power level 99 dB (A). [. . . ] INSERTING TOOLS Before any work on the machine itself, pull the mains plug!Insert the tool while turning into the tool holder until it latches. Take care that the dust protection cap 2 is not damaged. The chisel can now be turned by hand to the required working position. return the rotation stop switch 4 to the initial position . The chisel latches automatically as soon as it is radially loaded by the working or chiselling process. After the tile is drilled through, switch to impact drilling. SCREWDRIVING Screwdriver bits can be inserted into the adapter 13 (accessory). The screwdriver bits are held in the adapter with a spring ring. For drilling work in metal, wood and plastic with drills that have normal shafts, a drill chuck (13 mm max. All common drill chucks with 1/2" x 20 UNF internal threads (13 mm max. MOUNTING THE CHUCK Before any work on the machine itself, pull the mains plug! clean the threads of the drill chuck (accessory) and the adapter 13 (accessory). Screw the drill chuck onto the adapter and lock the adapter in the same manner as a drill in the tool holder. Remove the load from the machine immediately by pulling back the drill. Always hold the machine firmly with both hands and take a secure stance. Before any work on the machine itself, pull the mains plug! always keep the ventilation slots clean. Wipe off the accessible plastic parts regularly with a cloth without cleaning agent. After heavy use over a long period, the machine should be taken to a Kress service location for an inspection and thorough cleaning. Do not drill into hidden electrical lines or gas and water pipes. Check the area to be worked with a metal detector, for example, before starting. [. . . ] We reserve the right to repair defective parts or replace them with new parts. Improper use or handling as well as opening of the machine by unauthorised repair agencies voids the guarantee. Parts subject to wear are excluded from the guarantee. The guarantee may only be enforced when defects are reported without undue delay (including shipping damage). [. . . ]