User manual KRESS SPS 650W

[. . . ] SPS-DE / 0912 Original instructions "Jig saw“ Symbols and abbreviations English 15 Work area Keep work area clean and well lit. cluttered and dark areas invite to accidents. Do not operate power tools in explosive atmospheres, such as in the presence of flammable liquids, gases or dust. Power tools create sparks which may ignite dust or fumes. [. . . ] Putting into operation Observe correct main voltage!Before putting into operation, check that the mains voltage and frequency on the identification plate match the details of your mains supply.  Connect mains cable module If using an extension cable: Only use extension cables specifically approved for the application with the required cross-section. Otherwise the power of the tool can be reduced and the cable can overheat. Mains cable If the mains cable is damaged while working, pull the mains plug immediately. mains cable module Mains cable module with Patent Quick Interlock. Connect the mains cable module 12 to the handle. Use the mains cable module 12 only for Kress electric tools. Do not attempt to operate other machines with the module. damaged mains cable modules must not be used. They must be replaced by a new Kress mains cable module immediately. Push the two unlocking buttons 13 and remove the mains cable module 12 from the handle. Use only an original Kress mains cable module and at least a heavy rubber tube cable (H07RNF). Restarting protection The restarting protection feature prevents uncontrolled restarting of the machine after an interruption in the power supply.  To restart the operation, switch the On/Off switch 1 to the Off position and start the machine again. Pendulum stroke setting The change-over from the setting 0-3 is effected by means of the pendulum-stroke adjusting knob 7 (turning knob). The mark indicates the pendulum stroke selected. recommendations for pendulum stroke settings Pos. 0 for glass, ceramics, soft steel, nonferrous metals, aluminium and pressed materials Pos. 3 for plastics for plywood for hardwood, softtextured wood, chipboard It should be noted that the values given are standard values which may vary according to thickness and hardness of material, grain direction, and also to the condition of the saw blade. The optimal orbital action setting for the respective application can be determined through practical testing. The following recommendations apply:  Select a lower orbital action setting (or switch it off) for a finer and cleaner cutting edge. [. . . ] , damage caused by penetration of water or other fluids, cut and damaged cables, motor damage and mechanical damage caused by inappropriate overloading, wear parts e. Carbon brushes, drill chucks, chuck keys, worn drilling spindles, motors, mains cables, batteries, saw blades, grinding discs, dust bags, accessories in general (drill bits, chisels etc. Details of the various toll wear parts can be obtained from http:// spareparts. The warranty may only be enforced when defects are reported without undue delay (including shipping damage). [. . . ]