User manual KRESS WS 1000

[. . . ] Keep children and bystanders away while operating a power tool. Distractions can cause you to lose control. Electrical safety Power tool plugs must match the outlet. Do not use any adapter plugs with earthed (grounded) power tools. [. . . ] The router bit can become damaged and lead to increased vibrations. Take protective measures if there is danger of formation of combustible or explosive dust during operation that can be hazardous to health. example: Some dusts can be carcinogenic. Wear a dust mask and work with a dust/chip extraction unit, if possible to connect. Always wait until the machine has come to a complete stop before placing it down. The tool insert can jam and lead to loss of control over the power tool. During operation, always ensure that the mains and extension cable is to the rear away from the device. This prevents anyone from tripping over the cable while working. Move the switch to the "OFF" position before removing the plug from the plug socket. When the tool is reconnected to the mains accidental starting of the machine is avoided, thus reducing the risk of accidents. Tools not in use must be locked away safely in a dry place out of the reach of children. This could lead to underestimation of vibration when the tool is used regularly in such a manner. Note: To be accurate, an estimation of the level of exposure to vibration experienced during a given period of work should also take into account the times when the tool is switched off and when it is running but not actually when doing the job. This may significantly reduce the exposure level over the total working period. Identify additional safety measures to protect the operator from the effects of vibration such as: maintain the tool and accessories, keep the hands warm, organisation of work patterns. Before carrying out any work on the EN machine, pull the mains plug. Before putting into operation, check that the mains voltage and frequency on the identification plate match the details of your mains supply. If the mains cable is damaged while working, pull the mains plug immediately. Fixed power supply Fixed power supply Damaged mains cables must not be used. They must be replaced immediately by an expert technician. Use the mains cable module 7 only for Kress electric tools. Do not attempt to operate other machines with the module. [. . . ] always keep the machine and ventilation slots clean. Regularly wipe off the plastic parts which are accessible from the outside using a cloth without cleaning agent. After each job, blow the dust from the fan. This will increase your machine's service life. [. . . ]